[MirageOS-devel] Installing Mirage on Cubietruck

[Ahmed Ismail <a.m.ismail@xxxxxxxxxxxx>]

Good day,

To get straight to the point, I've been interested in Mirage over the last couple of weeks, and would like to continue using it over the coming years. My target platform is the cubietruck (CT); however, I've been running into a number of problems in trying to get it up and running.

Currently, the main issue I'm facing is that 'opam install mirage' doesn't proceed beyond the following point: "Processing Â4/17: [ocamlfind: make all]". I've actually left it overnight, twice, using cleanly built images sourced from two completely seperate computers for each respective run, but it always gets stuck here.

Has anyone else faced this issue? If so, how have you gotten past it?

Another point I'd like to bring up concerns the auto-built CB2/3 images. I think I read earlier that you asked to be informed if anyone was facing any issues Âthem. For some reason the CT image doesn't work. The CT consistently boots into NAND. I went out and got a serial cable to see why, and it just doesn't recognize that there's anything boot-able on the sd card. I got past this point by manually building the image.

I took notes on the steps I used diligently. For brevity, I didn't include them in this email, however, I would be more than happy to share them if they'll help.

Thank you in advance,

--

Ahmed

_______________________________________________
MirageOS-devel mailing list
MirageOS-devel@xxxxxxxxxxxxxxxxxxxx
http://lists.xenproject.org/cgi-bin/mailman/listinfo/mirageos-devel