Re: [Wg-test-framework] Notes from Dec 10 meeting with AllNet

["Paul L. George" <pgeorge@xxxxxxxxxx>]

Don, 

I know that the Comtrol Controller , Multiplexor and RJ45 to Serial adaptors
al worked when they tested it in a windows environment.  I believe
electrically and signal wise  everything is OK.  We can get tech support
from Comtrol if you need it.

Paul

-----Original Message-----
From: Don Koch [mailto:dkoch@xxxxxxxxxxx] 
Sent: Wednesday, December 10, 2014 4:56 PM
To: Don Koch
Cc: pgeorge@xxxxxxxxxx; 'Lars Kurth'; Ian Jackson;
wg-test-framework@xxxxxxxxxxxxxxxxxxxx
Subject: Re: [Wg-test-framework] Notes from Dec 10 meeting with AllNet

On Wed, 10 Dec 2014 15:38:36 -0500
Don Koch <dkoch@xxxxxxxxxxx> wrote:

> On Wed, 10 Dec 2014 14:15:42 -0500
> "Paul L. George(Office)" <pgeorge@xxxxxxxxxx> wrote:
> 
> > Ian, Lars
> > 
> >  
> > 
> > Comtrol RocketPort controllers are configured and connected.  
> > Newcastle is connected from newcastel rocketport position 1 to 
> > gateshead's serial port, and Gateshead is connected from gateshead 
> > rocketport position 1 to Newcastle's serial port.
> 
> Currently having issues with this. The rocket.ko module loads, claims 
> there are no rocket ports, then unloads. Don't know if this is a 
> not-supported-hardware issue or a not-set-up-correctly issue (or something
else).
> 
> Paul, which model Rocketport is this?

Figured it out: Rocketport express 32.

Found a new driver on their site (after going through a bad "not there"
link).
Built and it seems to find the ports. Not yet talking to the other side,
yet.

Need to leave; so, I'll poke at it in the morning.

-d


_______________________________________________
Wg-test-framework mailing list
Wg-test-framework@xxxxxxxxxxxxxxxxxxxx
http://lists.xenproject.org/cgi-bin/mailman/listinfo/wg-test-framework