[RFC: PATCH 4/5] Remove REV from DeviceID

[Owen Smith <owen.smith@xxxxxxxxx>]

Driver upgrades use HardwareIDs (or CompatibleIDs) to match the child INF 
DDInstall
section (stored as matching device id), but use the DeviceID to generate the 
device
instance path. By keeping the device instance path the same over upgrades, the 
network
stack should identify this as an upgrade, rather than 'replacement hardware', 
and
not generate a new network connection, which would require network settings to 
be
copied from the existing network connection to the new network connection.

Signed-off-by: Owen Smith <owen.smith@xxxxxxxxx>
---
 src/xenvif/pdo.c | 10 ++--------
 1 file changed, 2 insertions(+), 8 deletions(-)

diff --git a/src/xenvif/pdo.c b/src/xenvif/pdo.c
index d43702e..288419c 100644
--- a/src/xenvif/pdo.c
+++ b/src/xenvif/pdo.c
@@ -2062,18 +2062,12 @@ PdoQueryId(
         break;
 
     case BusQueryDeviceID: {
-        ULONG                   Index;
-        PXENVIF_PDO_REVISION    Revision;
-
         Type = REG_SZ;
-        Index = ARRAYSIZE(PdoRevision) - 1;
-        Revision = &PdoRevision[Index];
 
         status = RtlStringCbPrintfW(Buffer,
                                     Id.MaximumLength,
-                                    L"XENVIF\\VEN_%hs&DEV_NET&REV_%08X",
-                                    __PdoGetVendorName(Pdo),
-                                    Revision->Number);
+                                    L"XENVIF\\VEN_%hs&DEV_NET",
+                                    __PdoGetVendorName(Pdo));
         ASSERT(NT_SUCCESS(status));
 
         Buffer += wcslen(Buffer);
-- 
2.41.0.windows.3