[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Xen-API] PCI passthrough - XCP vs XenServer


> > your command should look like this:
> >  # xe vm-param-set other-config:pci=0/0000:05:00.0,0/0000:05:00.2
> > uuid=7a1f3bcd-4b2d-4c10-5aa4-4238a48f011d
> Thanks Marien. Unfortunately, even when I run the command like that I only
> see 1 of the 2 when I run lspci on my VM, so for some reason it's not getting
> passed through properly :( Perhaps it's something to do with this particular
> card, I don't know, but I'm a little stuck now.

IIRC there's been some confusion in the past about what the first number ("0/") 
means in the PCI passthrough syntax. It's possible that some of the code is 
interpreting it as a virtual slot number of a plug ordering (or both). Try 
using the string


Just in case there's a bug in the reboot code, I recommend powering off the VM 
and then starting it, rather than rebooting.


Xen-api mailing list



Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.