Re: [Xen-API] xen + xapi + xencenter

[Dave Scott <Dave.Scott@xxxxxxxxxx>]

> On 8 Jan 2015, at 13:17, Renato Fontana <skyrenato@xxxxxxxxx> wrote:
> 
> Hi everyone!
> 
> I have installed xen via apt-get (xen-hypervisor-4.1), added xapi toolstack 
> and installed xencenter to manage my servers remotely. Is this setup ok? As 
> far as I know, xencenter uses xapi to access the hypervisors..but I can't get 
> it to connect. I'm receiving a "the connection was refused" after I try to 
> connect/add servers. Any advice ?

Iâd check the simple stuff first: is stunnel listening on port 443 and xapi on 
port 80? If so then it might be a firewall rule problem.

It could be that xapi hasnât got a configured âmanagement interfaceâ.

If âxe pif-listâ is empty, then you could populate it by running âxe pif-scan 
host-uuid=<my host uuid>â (use âxe host-listâ to see the host uuids)

Make sure that at least one of the âpifsâ (i.e. physical interfaces) has an IP 
address configuration e.g. with

xe pif-configure-ip uuid=â mode=dhcp

Make sure that at least one of the âpifsâ has the âmanagementâ flag set. If âxe 
pif-list management=trueâ is empty then try

xe host-management-reconfigure pif-uuid=â

Good luck!

Dave
_______________________________________________
Xen-api mailing list
Xen-api@xxxxxxxxxxxxx
http://lists.xen.org/cgi-bin/mailman/listinfo/xen-api