[XenARM] Problems when booting on OMAP5432 devboard

[Chen Baozi <baozich@xxxxxxxxx>]

Hi Ian,

After enabling the UART, I have been tring to finish the rest of booting.
However, the output information stops at "Placing Xen at XXXX-XXXX" like
following:

Starting kernel ...

- UART enabled -
- CPU 00000000 booting -
- Machine ID 00000ec1 -
- Started in Hyp mode -
- Zero BSS -
- Setting up control registers -
- Turning on paging -
- Ready -
RAM: 0000000080000000 - 00000000ffffffff

MODULE[1]: 00000000a0000000 - 00000000a0400000 
Placing Xen at 0x00000000ffe00000-0x0000000100000000

What could be the most possible problem of this case?

Thanks,

Baozi

_______________________________________________
Xen-arm mailing list
Xen-arm@xxxxxxxxxxxxx
http://lists.xen.org/cgi-bin/mailman/listinfo/xen-arm