Re: [Xen-ia64-devel] Is xend running??

[Alex Williamson <alex.williamson@xxxxxx>]

On Fri, 2007-12-07 at 12:17 -0700, Alex Williamson wrote:
> On Fri, 2007-12-07 at 17:06 -0200, juliano potrich wrote:
> > I installed debian ia64 on a itanium rx2600, and then cloned the
> > xen-unstable image from 
> > http://xenbits.xensource.com/ext/ia64/xen-unstable.hg
> > but, when I boot the XEN kernel, I can't start xend. 
> > Actually, the command xend start returns nothing, but when I try the
> > "xm list", the display shows that message: "... Is xend running?"
> > 
> > Opening /var/log/xen/xend.log, the error message is the following: 
> > Exception starting xend ((111, 'Connection refused'))
> > 
> > Could someone please give a help???? 
> 
>    Did you build and install both a hypervisor and a xen enabled
> vmlinux?  Can you post your elilo.conf and console boot log?  If xend
> won't start, it seems like maybe you're not really running dom0.  You
> should get a lot of lines starting with (XEN) early in boot, which
> should be easy to spot in the console log (note these won't show up in
> dmesg from linux).  You should also have a /proc/xen directory
> and /proc/interrupts should look a lot different if you're successfully
> running dom0.  Thanks,

   Also, since you're on debian, do not install _any_ of the xen related
packages in debian.  If you have already, dpkg --purge them.  They are
much older than what's in the tree you cloned and mixing them together
will likely cause strange problems.  Thanks,

        Alex

-- 
Alex Williamson                             HP Open Source & Linux Org.


_______________________________________________
Xen-ia64-devel mailing list
Xen-ia64-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-ia64-devel