Re: [XenPPC] Booting Dom0 with SLES10 on JS21

[Jimi Xenidis <jimix@xxxxxxxxxxxxxx>]

On Jul 11, 2006, at 2:08 PM, Jimi Xenidis wrote:

> On Jul 11, 2006, at 1:44 PM, poff wrote:
>
> > Xenidis wrote:
> > > > > Then try using <linux build>/arch/powerpc/boot/zImage.initrd as  
> > > > > your
> > > > > Dom0
> > Much better... However still endup with:
> >      INIT: Id "1" respawning too fast: disabled for 5 minutes
> Those are entries in /etc/inittab, it usually means that getty  
> doesn't like the device it is associated with.
> There still might be some udev issues.
It occurs to me that the udev being used may be incompatible with our  
kernel?
Not sure about this since I use the same distro on my maple and do  
not have this problem.
  mapled:~ # rpm -qa udev
  udev-085-30

I'm not sure how to properly debug this, perhaps you can boot with  
"init=/bin/bash" and the from the prompt run:
  # /etc/init.d/boot start

that should mount and start up the udevd.
then inspect /dev/ to see if the tty's entries exist.
-JX

_______________________________________________
Xen-ppc-devel mailing list
Xen-ppc-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-ppc-devel