[Xen-users] Boot up

[Shahzad Chohan <shahzad.chohan@xxxxxxxxx>]

Hi

I installed rhel 3 using a cdrom in the normal way but without
installing the bootloader. The problem is that it won't boot up. Below
is the bootup messages, as you can see it on;y goes as far as freeing
unused memory, then it stops. Any ideas on this?

xen_blk: Initialising virtual block device driver
xen_net: Initialising virtual ethernet driver.
md: md driver 0.90.1 MAX_MD_DEVS=256, MD_SB_DISKS=27
NET: Registered protocol family 2
IP: routing cache hash table of 256 buckets, 4Kbytes
TCP established hash table entries: 4096 (order: 4, 65536 bytes)
TCP bind hash table entries: 4096 (order: 3, 49152 bytes)
TCP: Hash tables configured (established 4096 bind 4096)
Initializing IPsec netlink socket
NET: Registered protocol family 1
NET: Registered protocol family 17
md: Autodetecting RAID arrays.
md: autorun ...
md: ... autorun DONE.
kjournald starting.  Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
VFS: Mounted root (ext3 filesystem) readonly.
Freeing unused kernel memory: 156k freed

Thanks
Shaz

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users