Re: [Xen-users] network connection to and from domain0 does not work

["Kevin Schroeder" <kschroeder@xxxxxxxxxxxxxxx>]

Rigas,
   If you're using bridging check to see if you have the brctl controls 
installed.  I ran into the same problem and it was because brctl wasn't on 
my system and XEN didn't report an error when it tried to create a bridge. 
You may be able to tell if once you start your XEN vm's you type ifconfig 
and you don't see a xen-br0 interface.
Kevin

----- Original Message ----- 
From: "Rigas Wendel" <beerman_wendel@xxxxxxxx>
To: "Xen userlist Userlist" <xen-users@xxxxxxxxxxxxxxxxxxx>
Sent: Saturday, June 18, 2005 6:21 AM
Subject: [Xen-users] network connection to and from domain0 does not work


Hello everybody,

I installed Xen on my suse 9.2 system. Up to now I can
do the following things:

Boot into XEN
Start xend
Automatically start a virtual Domain (ttylinux)

My problem is that after starting XEN I cannot reach
any other client on my network any more.
The only machine I can ping is the virtual ttylinux
vm.
Therefore I cannot reach the XEN machine from outside
using ssh or telnet.

The ttylinux itself vm works fine. From there I can
reach every other machine in my network using ping!!!
So the nic itself should not be the problem.

Regards

Rigas








___________________________________________________________
Gesendet von Yahoo! Mail - Jetzt mit 1GB Speicher kostenlos - Hier anmelden: 
http://mail.yahoo.de
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users




_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users