[Xen-users] Xen 2.0.7 , amd64 (32 bit mode) lvm partition: runaway loop modprobe binfmt-464c

[Robin van Leeuwen <robin.van.leeuwen@xxxxxxxxxxxxxxxxxxx>]

Hi i'm trying to run Xen on my amd64. Installed is
Debian 3.1 sarge i386 and Xen 2.0.7, my whole enviroment
is 32 bit.

When i'm running a xenU domain and use /var/xen/samba
as a ext2 fs file ( file:/var/xen/samba,hda1,w ) everything
goes according to plan.

If i use my LVM partition ( phy:/dev/xen/samba-ha,hda1,w )
it gives during boot:

--------
       ...
       NET: Registered protocol family 17
       IP-Config: Complete:
             device=eth0, addr=192.168.2.10, mask=255.255.255.0,
gw=192.168.2.1,
            host=samba-ha, domain=, nis-domain=(none),
            bootserver=1.2.3.4, rootserver=1.2.3.4, rootpath=
       kjournald starting.  Commit interval 5 seconds
       EXT3-fs: mounted filesystem with ordered data mode.
       VFS: Mounted root (ext3 filesystem) readonly.
       Freeing unused kernel memory: 112k freed
       request_module: runaway loop modprobe binfmt-464c
       request_module: runaway loop modprobe binfmt-464c
       request_module: runaway loop modprobe binfmt-464c
       request_module: runaway loop modprobe binfmt-464c
       request_module: runaway loop modprobe binfmt-464c
-------


my setup:

#lvscan
 ACTIVE            '/dev/xen/samba-ha' [500,00 MB] inherit

in my config file:  disk = ['phy:/dev/xen/samba-ha,hda1,w']


anybody any suggestions?

kind regards,

Robin van Leeuwen




_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users