Linux version 2.6.11.12-xen0 (xenod@xxxxxxxxxxxxxxxxxxxxx) (gcc version 3.3.3 20040412 (Red Hat Linux 3.3.3-7)) #1 Thu Aug 4 00:45:12 BST 2005 BIOS-provided physical RAM map: Xen: 0000000000000000 - 0000000010000000 (usable) 256MB LOWMEM available. On node 0 totalpages: 65536 DMA zone: 65536 pages, LIFO batch:16 Normal zone: 0 pages, LIFO batch:1 HighMem zone: 0 pages, LIFO batch:1 DMI 2.3 present. IRQ lockup detection disabled Allocating PCI resources starting at 10000000 (gap: 10000000:f0000000) Built 1 zonelists Kernel command line: root=/dev/hdc1 vga=0x314 debug Initializing CPU#0 PID hash table entries: 2048 (order: 11, 32768 bytes) Xen reported: 3065.838 MHz processor. Using tsc for high-res timesource Console: colour VGA+ 80x25 Dentry cache hash table entries: 65536 (order: 6, 262144 bytes) Inode-cache hash table entries: 32768 (order: 5, 131072 bytes) vmalloc area: d0800000-fbef9000, maxmem 34000000 Memory: 254336k/262144k available (2979k kernel code, 7496k reserved, 946k data, 324k init, 0k highmem) Checking if this processor honours the WP bit even in supervisor mode... Ok. Calibrating delay loop... 6121.06 BogoMIPS (lpj=30605312) Mount-cache hash table entries: 512 (order: 0, 4096 bytes) CPU: After generic identify, caps: bfebfbff 00000000 00000000 00000000 00004400 00000000 00000000 CPU: After vendor identify, caps: bfebfbff 00000000 00000000 00000000 00004400 00000000 00000000 CPU: Trace cache: 12K uops, L1 D cache: 8K CPU: L2 cache: 512K CPU: After all inits, caps: bfebd3f1 00000000 00000000 00000080 00004400 00000000 00000000 CPU: Intel(R) Xeon(TM) CPU 3.06GHz stepping 09 Enabling fast FPU save and restore... done. Enabling unmasked SIMD FPU exception support... done. Checking 'hlt' instruction... disabled NET: Registered protocol family 16 PCI: Using configuration type Xen xen_mem: Initialising balloon driver. SCSI subsystem initialized usbcore: registered new driver hub PCI: Probing PCI hardware PCI: Probing PCI hardware (bus 00) PCI: Ignoring BAR0-3 of IDE controller 0000:00:1f.1 PCI: Transparent bridge - 0000:00:1e.0 PCI: Probing PCI hardware (bus 01) PCI: Probing PCI hardware (bus 02) PCI: Probing PCI hardware (bus 05) PCI: Probing PCI hardware (bus 06) PCI: Probing PCI hardware (bus 07) PCI: Probing PCI hardware IA-32 Microcode Update Driver: v1.14-xen Initializing Cryptographic API serio: i8042 AUX port at 0x60,0x64 irq 12 serio: i8042 KBD port at 0x60,0x64 irq 1 io scheduler noop registered io scheduler anticipatory registered io scheduler deadline registered io scheduler cfq registered Floppy drive(s): fd0 is 1.44M FDC 0 is a post-1991 82077 RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize loop: loaded (max 8 devices) HP CISS Driver (v 2.6.4) Intel(R) PRO/1000 Network Driver - version 5.6.10.1-k2 Copyright (c) 1999-2004 Intel Corporation. PCI: Obtained IRQ 48 for device 0000:07:01.0 e1000: eth0: e1000_probe: Intel(R) PRO/1000 Network Connection PCI: Obtained IRQ 49 for device 0000:07:01.1 e1000: eth1: e1000_probe: Intel(R) PRO/1000 Network Connection pcnet32.c:v1.30i 06.28.2004 tsbogend@xxxxxxxxxxxxxxxx e100: Intel(R) PRO/100 Network Driver, 3.3.6-k2-NAPI e100: Copyright(c) 1999-2004 Intel Corporation PCI: Obtained IRQ 19 for device 0000:01:01.0 e100: eth2: e100_probe: addr 0xfe4fe000, irq 19, MAC addr 00:E0:81:2B:15:D1 Xen virtual console successfully installed as ttyS Event-channel device installed. Initialising Xen netif backend Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx ICH3: IDE controller at PCI slot 0000:00:1f.1 PCI: Enabling device 0000:00:1f.1 (0005 -> 0007) PCI: Obtained IRQ 18 for device 0000:00:1f.1 ICH3: chipset revision 2 ICH3: not 100% native mode: will probe irqs later ide0: BM-DMA at 0xffa0-0xffa7, BIOS settings: hda:DMA, hdb:pio ide1: BM-DMA at 0xffa8-0xffaf, BIOS settings: hdc:DMA, hdd:DMA Probing IDE interface ide0... hda: ST3120026A, ATA DISK drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 Probing IDE interface ide1... hdc: ST3120026A, ATA DISK drive hdd: SAMSUNG CD-R/RW DRIVE SW-252F, ATAPI CD/DVD-ROM drive ide1 at 0x170-0x177,0x376 on irq 15 Probing IDE interface ide2... Probing IDE interface ide3... Probing IDE interface ide4... Probing IDE interface ide5... hda: max request size: 1024KiB hda: 234441648 sectors (120034 MB) w/8192KiB Cache, CHS=16383/255/63, UDMA(100) hda: cache flushes supported hda: hda1 hda2 hda3 < hda5 > hdc: max request size: 1024KiB hdc: 234441648 sectors (120034 MB) w/8192KiB Cache, CHS=16383/255/63, UDMA(33) hdc: cache flushes supported hdc: hdc1 hdd: ATAPI 1X CD-ROM CD-R/RW drive, 2048kB Cache, UDMA(33) Uniform CD-ROM driver Revision: 3.20 Red Hat/Adaptec aacraid driver (1.1.2-lk2 Aug 4 2005) 3ware Storage Controller device driver for Linux v1.26.02.000. libata version 1.10 loaded. Fusion MPT base driver 3.01.18 Copyright (c) 1999-2004 LSI Logic Corporation Fusion MPT SCSI Host driver 3.01.18 ohci_hcd: 2004 Nov 08 USB 1.1 'Open' Host Controller (OHCI) Driver (PCI) USB Universal Host Controller Interface driver v2.2 PCI: Obtained IRQ 16 for device 0000:00:1d.0 uhci_hcd 0000:00:1d.0: UHCI Host Controller PCI: Setting latency timer of device 0000:00:1d.0 to 64 uhci_hcd 0000:00:1d.0: irq 16, io base 0xec00 uhci_hcd 0000:00:1d.0: new USB bus registered, assigned bus number 1 hub 1-0:1.0: USB hub found hub 1-0:1.0: 2 ports detected usbcore: registered new driver usbhid drivers/usb/input/hid-core.c: v2.0:USB HID core driver mice: PS/2 mouse device common for all mice input: AT Translated Set 2 keyboard on isa0060/serio0 input: PS/2 Logitech Mouse on isa0060/serio1 md: raid0 personality registered as nr 2 md: raid1 personality registered as nr 3 md: raid5 personality registered as nr 4 raid5: automatically using best checksumming function: pIII_sse pIII_sse : 2697.200 MB/sec raid5: using function: pIII_sse (2697.200 MB/sec) md: md driver 0.90.1 MAX_MD_DEVS=256, MD_SB_DISKS=27 device-mapper: 4.4.0-ioctl (2005-01-12) initialised: dm-devel@xxxxxxxxxx NET: Registered protocol family 2 IP: routing cache hash table of 2048 buckets, 16Kbytes TCP established hash table entries: 16384 (order: 5, 131072 bytes) TCP bind hash table entries: 16384 (order: 4, 65536 bytes) TCP: Hash tables configured (established 16384 bind 16384) NET: Registered protocol family 1 NET: Registered protocol family 17 Bridge firewalling registered md: Autodetecting RAID arrays. md: autorun ... md: ... autorun DONE. ReiserFS: hdc1: found reiserfs format "3.6" with standard journal ReiserFS: hdc1: using ordered data mode ReiserFS: hdc1: journal params: device hdc1, size 8192, journal first block 18, max trans len 1024, max batch 900, max commit age 30, max trans age 30 ReiserFS: hdc1: checking transaction log (hdc1) ReiserFS: hdc1: Using r5 hash to sort names VFS: Mounted root (reiserfs filesystem). Freeing unused kernel memory: 324k freed Adding 1052248k swap on /dev/hda2. Priority:42 extents:1 md: raidstart(pid 1187) used deprecated START_ARRAY ioctl. This will not be supported beyond 2.6 md: could not open unknown-block(33,1). md: autostart failed! md: Autodetecting RAID arrays. md: autorun ... md: ... autorun DONE.