[Xen-users] Re: Fibre Channel Problem

[John S Little <JSLittl@xxxxxxxxxxxxx>]

Thomas..

> I did build in ....
> 
> But it won't work! Could you please send me some .configs where your 
qla2312
> is working?!?!?!??!?!
> 
> 
> 
> Thomas Diederich
> 

If you used the 

# make KERNELS=linux-2.6-xen world
# make install
 
commands for your initial install the drver is built statically and will 
not show up as a module under lsmod.  Have a look at /var/log/boot.msg (or 
whatever the equivalent is on Red Hat).  Following is my output from a 
sles9 box:

xen0:~ # grep -i qla /var/log/boot.msg
<6>qla2300 0000:02:05.0: Found an ISP2312, irq 24, iobase 
0xffffc20000006000
<6>qla2300 0000:02:05.0: Configuring PCI space...
<6>qla2300 0000:02:05.0: Configure NVRAM parameters...
<6>qla2300 0000:02:05.0: Verifying loaded RISC code...
<6>qla2300 0000:02:05.0: Waiting for LIP to complete...
<6>qla2300 0000:02:05.0: Cable is unplugged...
<6>scsi0 : qla2xxx
<6>qla2300 0000:02:05.0:
<4>  QLogic QLA2342 - 133MHz PCI-X to 2Gb FC, Dual Channel
<6>qla2300 0000:02:05.1: Found an ISP2312, irq 25, iobase 
0xffffc20000026000
<6>qla2300 0000:02:05.1: Configuring PCI space...
<6>qla2300 0000:02:05.1: Configure NVRAM parameters...
<6>qla2300 0000:02:05.1: Verifying loaded RISC code...
<6>qla2300 0000:02:05.1: Waiting for LIP to complete...
<6>qla2300 0000:02:05.1: Cable is unplugged...
<6>scsi1 : qla2xxx
<6>qla2300 0000:02:05.1:
<4>  QLogic QLA2342 - 133MHz PCI-X to 2Gb FC, Dual Channel
xen0:~ #

I also get the same output from the command:   dmesg |grep -i qla.

hth

Regards,

John Little
Hendricks Regional Health IS Department
317-718-4752
jslittl@xxxxxxxxxxxxx
http://www.hendrickshospital.org


_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users