Re: [Xen-users] only one NIC supported?

[Rowan Woodhouse <rowan@xxxxxxxxxxxxx>]

Hi,

try:

# ./network-bridge start bridge=xenbr1 netdev=eth1 vifnum=1

which will cause xen to use veth1 rather than veth0 which is probably 
being used for xenbr0.
Regards,

Rowan

David Koski wrote:
> After upgrading amd64 from 3.0.0 to 3.0.1 I can only start one bridge.
> When trying to manualy start another bridge with:
>
> # ./network-bridge start bridge=xenbr1 netdev=eth1
>
> ..I get the following error:
>
> Link veth0 is missing.
> This may be because you have reached the limit of the number of interfaces
> that the loopback driver supports.  If the loopback driver is a module, you
> may raise this limit by passing it as a parameter (nloopbacks=<N>); if the
> driver is compiled statically into the kernel, then you may set the parameter
> using loopback.nloopbacks=<N> on the domain 0 kernel command line.
>
> How do I get my other bridge up? Is it really a lack of loopbacks?
>
> Also, what should xend-config.sxp look like for two NICs bridged? The
> documentation is very vague.
>
> Regards,
> David
>
>
>
>
> _______________________________________________
> Xen-users mailing list
> Xen-users@xxxxxxxxxxxxxxxxxxx
> http://lists.xensource.com/xen-users
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users