Re: [Xen-users] help VMX guest and networking xen 3.0.1

[Adam Wendt <adam@xxxxxxxxxxx>]

I believe you need to have correct entry in the guest config file:

vif = [ 'type=ioemu, bridge=xenbr0' ]

Hope this helps,

Adam Wendt
IPCoast, Inc.


On Mon, 20 Feb 2006 17:19 , 'Jesús_Velazquez' <jesus.velazquez@xxxxxxxxx> sent:

>Hi, I'm working with Xen 3.0.1 and I have the following problem:
>
>I'm running Xen in a VT enabled Intel processor, I have successful
>installed a Fedora Core 4 32 bits Guest using VT. But the
>Network interface doesn't appear in the Guest. I mean, running the
>commands "ifconfig ?a" doesn't show any eth0 interface just lo.
>In the /sys/class/net directory there is not any ethX interface and
>neither in the dmesg log appears nothing about eth0.
>Finally when I run the command: lspci ?v, there are the following devices:
>
>Host bridge: Intel Corporation 440FX
>ISA bridge: Intel Corporation 82371SB
>IDE interface: Intel Corporation 82371SB
>VGA compatible controller: Cirrus Logic GD
>
>And anything about a Network interface.
>
>What can I do?, running a Linux Paravirtualized Guest (xenU) shows the
>interface eth0 without any problem.
>
>I adjusted the .config file for the xen0 domain. I added EHCI support
>and USB mass storage, and also support for SMP machines.
>I did it using the following command:
>
>In the xen directory:
>
>
>make linux-2.6-xen0-config CONFIGMODE=menuconfig
>make linux-2.6-xen0-build
>make linux-2.6-xen0-install
>
>And reboot.
>
>What options are needed in the .config file for Xen0 in order to
>create the virtual network devices in the VMX guests?
>
>Thanks
>
>_______________________________________________
>Xen-users mailing list
>Xen-users@xxxxxxxxxxxxxxxxxxx
>http://lists.xensource.com/xen-users
>





_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users