Re: [Xen-users] xen3 with bind in domU - SOLVED

["Daniel Bauer" <mlist@xxxxxxxxxxx>]

From: "Pasi Kärkkäinen" <pasik@xxxxxx>
> On Tue, Mar 14, 2006 at 08:03:52PM +0100, Daniel Bauer wrote:
> > From: "Goetz Bock" <bock@xxxxxxxxxxx>
> > >On Tue, Mar 14 '06 at 18:28, Daniel Bauer wrote:
> > >>if I start a query at the domU bind from the inside of the network 
> > >>it
> > >>works, if I start the same query from the outside of the network 
> > >>then
> > >>it fails.
> > >
> > >ethtool -K eth0 tx off
> > >
> > >on all interfaces DomU and Dom0. For the firewall eth1, too.
> >
> > Thanks a lot, this works great, but only in the domU not in the dom0.
> Is this "tx off" really needed also in dom0?
In dom0 I get the error message "Cannot set device tx csum settings: 
Operation not supported". I couldn't use all features in my network 
(f.e. Tunnel device in the firewall for VPN), but that's not important 
for me, because I don't use dom0 for working.

> btw. what nics and what xen+kernel version are you using when
> you have these problems?
I'm using a standard SuSE 10.0 (kernel-xen-2.6.13-15.8) with XEN3 Build 
8800 installation. The nics are intel devices, maybe I have to give this 
command without running domU, but I don't wont to stop them.
Daniel 

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users