Re: [Xen-users] Re: Dell PowerEdge 2850 - irq X: nobody cared!

[Arjen Runsink <arjen@xxxxxxxxxxx>]

Hi,

I have had a lot of issues without even using Xen. My problem was that 
disabled on board hardware was not so disabled at all. In my case an onboard 
controller.

Reenabling the hardware made my system stable.

BB, Arjen

On Wednesday 12 April 2006 08:45, Paul Gear wrote:
> Michael Best wrote:
> > Any ideas about this?  I have seen suggestions about turning off USB,
> > but it would be nice if there is another solution.
> >
> > irq 18: nobody cared!
> > ...
> > Disabling IRQ #18
>
> I'm seeing the same thing (for IRQ 18 only) on a Dell PowerEdge SC1425
> dual Xeon 2.8 GHz.  Did you find any solution, Michael?
>
> Thanks,
> Paul

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users