|
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [Xen-users] help with xen networking on debian
hi everyone, i've managed to install xen on sid and sarge, using this useful howto: http://www.debian-administration.org/articles/320 i've got my virtual machine to startup, but networking doesnt really work! my setup is as follows: i have a router/gateway 192.168.1.1 my base host (moya) is 192.168.1.4 my virtual server (test18) is 192.168.1.18 from the virtual server, i can ping the base host and from the base host i can ping the server. however, when i try and ping the gateway, or anywhere else from the vitual server i get: "From 192.168.1.18 icmp_seq=1 Destination Host Unreachable" i also tried installing on sid and got exactly the same problem. i'm not trying to do any fancy networking, just to get it working "out of the box" :) here is some info from moya (base host): /etc/network/interfaces -------------------------------- hamish@moya:~$ cat /etc/network/interfaces # This file describes the network in terfaces available on your system # and how to activate them. For more information, see interfaces(5). # The loopback network interface auto lo iface lo inet loopback # The primary network interface auto eth0 iface eth0 inet static address 192.168.1.4 netmask 255.255.255.0 network 192.168.1.0 broadcast 192.168.1.255 gateway 192.168.1.1 # dns-* options are implemented by the resolvconf package, if installed dns-nameservers 210.55.12.1 route ------- moya:/home/hamish# route Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface localnet * 255.255.255.0 U 0 0 0 eth0 default 192.168.1.1 0.0.0.0 UG 0 0 0 eth0 ifconfig ---------- moya:/home/hamish# ifconfig eth0 Link encap:Ethernet HWaddr 00:13:72:FC:C0:66 inet addr:192.168.1.4 Bcast:192.168.1.255 Mask:255.255.255.0 inet6 addr: fe80::213:72ff:fefc:c066/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:2783 errors:0 dropped:0 overruns:0 frame:0 TX packets:738 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:196151 (191.5 KiB) TX bytes:70241 (68.5 KiB) lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 inet6 addr: ::1/128 Scope:Host UP LOOPBACK RUNNING MTU:16436 Metric:1 RX packets:8 errors:0 dropped:0 overruns:0 frame:0 TX packets:8 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:560 (560.0 b) TX bytes:560 (560.0 b) peth0 Link encap:Ethernet HWaddr FE:FF:FF:FF:FF:FF inet6 addr: fe80::fcff:ffff:feff:ffff/64 Scope:Link UP BROADCAST RUNNING NOARP MULTICAST MTU:1500 Metric:1 RX packets:2732 errors:0 dropped:0 overruns:0 frame:0 TX packets:755 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:204077 (199.2 KiB) TX bytes:76453 (74.6 KiB) Interrupt:16 vif0.0 Link encap:Ethernet HWaddr FE:FF:FF:FF:FF:FF inet6 addr: fe80::fcff:ffff:feff:ffff/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:738 errors:0 dropped:0 overruns:0 frame:0 TX packets:2788 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:70241 (68.5 KiB) TX bytes:196537 (191.9 KiB) vif4.0 Link encap:Ethernet HWaddr FE:FF:FF:FF:FF:FF inet6 addr: fe80::fcff:ffff:feff:ffff/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:35 errors:0 dropped:0 overruns:0 frame:0 TX packets:174 errors:0 dropped:140 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:1638 (1.5 KiB) TX bytes:10466 (10.2 KiB) xenbr0 Link encap:Ethernet HWaddr FE:FF:FF:FF:FF:FF inet6 addr: fe80::200:ff:fe00:0/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:2246 errors:0 dropped:0 overruns:0 frame:0 TX packets:5 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:107032 (104.5 KiB) TX bytes:378 (378.0 b) /etc/xen-tools/xen-tools.conf ----------------------------------------- moya:/home/hamish# cat /etc/xen-tools/xen-tools.conf # # /etc/xen-tools/xen-tools.conf # # Global configuration file for the scripts included with Xen-tools. # # Values may be set here so they don't need to be used upon the # command line. # # e.g. --hostname=bob becomes 'hostname = bob'. # --fs=ext3 becomes 'fs = ext3'. # # # ## # Output directory. Images are stored beneath this directory, one # subdirectory per hostname. ## dir = /home/xen ## # If you don't wish to use loopback images, stored beneath the directory # specified above with 'dir' then you may give an LVM volume name # instead: # ## # volume = xen-volume ## # Disk and Sizing options. ## size = 2Gb # Disk image size. memory = 128Mb # Memory size swap = 128Mb # Swap size fs = ext3 # use EXT3 filesystems dist = sarge # Default distribution to install. ## # Networking setup values. ## # # Uncomment these if you wish to use a static address via the --ip flag. # gateway = 192.168.1.1 netmask = 255.255.255.0 # # Uncomment this if you wish the images to use DHCP # # dhcp = 1 ## # Misc options ## # # Uncomment the following line if you wish to disable the caching # of downloaded .deb files. # # cache = no # # # Uncomment the following line if you wish to interactively setup # a new root password for images. # # passwd = 1 # # Default kernel for the virtual servers # kernel = /boot/xen-linux-2.6.12.6-xen # # Default mirror for debootstrap # mirror = http://ftp.us.debian.org/debian/ # # Uncomment if you wish newly created images to boot automatically. # # boot = 1 command to create xen virtual server ----------------------------------------------------- xen-create-image --ip=192.168.1.18 --hostname=test18 here is some info from the virtual server: /etc/network/interfaces -------------------------------- test18:~# cat /etc/network/interfaces # This file describes the network interfaces available on your system # and how to activate them. For more information, see interfaces(5). # The loopback network interface auto lo iface lo inet loopback # The primary network interface auto eth0 iface eth0 inet static address 192.168.1.18 gateway 192.168.1.1 netmask 255.255.255.0 route ------- test18:~# route Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface 192.168.1.0 * 255.255.255.0 U 0 0 0 eth0 default 192.168.1.1 0.0.0.0 UG 0 0 0 eth0 ifconfig ---------- test18:~# ifconfig eth0 Link encap:Ethernet HWaddr 00:16:3E:7F:CB:D4 inet addr:192.168.1.18 Bcast:192.168.1.255 Mask:255.255.255.0 inet6 addr: fe80::216:3eff:fe7f:cbd4/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:322 errors:0 dropped:0 overruns:0 frame:0 TX packets:41 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:19958 (19.4 KiB) TX bytes:1890 (1.8 KiB) lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 inet6 addr: ::1/128 Scope:Host UP LOOPBACK RUNNING MTU:16436 Metric:1 RX packets:14 errors:0 dropped:0 overruns:0 frame:0 TX packets:14 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:1284 (1.2 KiB) TX bytes:1284 (1.2 KiB) any help on this would be much appreciated! :) thanks, hamish _______________________________________________ Xen-users mailing list Xen-users@xxxxxxxxxxxxxxxxxxx http://lists.xensource.com/xen-users
|
 |
Lists.xenproject.org is hosted with RackSpace, monitoring our |