RE: [Xen-users] Sarge: Xen 3.0.2-2 on Opteron 64bit

["Bart van den Heuvel" <bart@xxxxxxxxxxxxxxxxxxxx>]

No worries...

The howto was for 3.0.1 not 3.0.2! Downloaded the 3.0.1 and now I can follow
te procedure.

Gr,

Bart

________________________________________
Van: xen-users-bounces@xxxxxxxxxxxxxxxxxxx
[mailto:xen-users-bounces@xxxxxxxxxxxxxxxxxxx] Namens Bart van den Heuvel
Verzonden: dinsdag 13 juni 2006 22:20
Aan: xen-users@xxxxxxxxxxxxxxxxxxx
Onderwerp: [Xen-users] Sarge: Xen 3.0.2-2 on Opteron 64bit

Hi, 

I´ve been using Xen 2 for a while now and i´m ready for the new 3.0 stuff.
Because i´m a fan of www.howtoforge.com I tried:
http://www.howtoforge.com/perfect_setup_xen3_debian. Trying to build Xen on
Debian Sarge using a brand new Sun fire X2100 I immediately ran into
trouble: 

cc1: sorry, unimplemented: 64-bit mode not compiled in

I have a 32bit install running a 64 bit kernel? (2.6.8-12-amd64-generic) So
I guess the packaged gcc was build without 64bit support, no problem. On the
neighbours mailinglist (developers) I came across the "make
XEN_COMPILE_ARCH=x86_32" tip, very helpful! 

It then compiled great! Even downloaded a new kernel for me. However, the
howto states that I go into the kernel dir and do the menuconfig. Using:

cd linux-2.6.16-xen0
ARCH=xen
export ARCH
make oldconfig
make menuconfig

But in there is no xen arch in this tree, only the x86_64 arch! I´m lost!
Can someone give me pointers on how to proceed? I want to compile a new
kernel because I want quota, iptables and dummy netdriver. Thanks?

Gr,

Bart


_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users