Re: [Xen-users] Re: network-bridge fails leaving tmpbridge around

["Daniel P. Berrange" <berrange@xxxxxxxxxx>]

On Fri, May 11, 2007 at 03:28:48PM +0200, Weismueller, Jonas wrote:
> Richard W.M. Jones wrote:
> >Richard W.M. Jones wrote:
> >>One thing that's a bit strange is the sudden presence of virbr0.  I 
> >>don't understand where it comes from.  Note: there is no libvirtd or 
> >>qemu running on this machine.
> >
> >Turns out that the mysterious presence of virbr0 was the clue.  Doing:
> >
> >  rm -r /var/lib/xend/state
> I've got the same problem. Removing the state directory didn't solve my 
> problem. Some output of ifconfig, route, brctl is attached to the mail

Actually re-reading your logs attached the prescence of 'virbr0' is OK
in your case - it was there before starting xend, so should be there
after.

Can you try something slightly different.

 - Turn off xend service so it doesn't start upon boot
 - Reboot
 - Run '/etc/xen/scripts/network-bridge start' manually

If that works, then can you reboot again & manually run
'/etc/init.d/xend start' instead. If that fails, I'd be intersted in
the xend.log & xend-debug.log

Regards,
Dan.
-- 
|=- Red Hat, Engineering, Emerging Technologies, Boston.  +1 978 392 2496 -=|
|=-           Perl modules: http://search.cpan.org/~danberr/              -=|
|=-               Projects: http://freshmeat.net/~danielpb/               -=|
|=-  GnuPG: 7D3B9505   F3C9 553F A1DA 4AC2 5648 23C1 B3DF F742 7D3B 9505  -=| 

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users