[Xen-users] Xen 3.1.0 initrd and kernel building

[amin <amin@xxxxxxx>]

Hi, had a few problems with using xen:


First:
built a xen from source (tgz) and make dist ... then made initrd with 
mkinitrd and modules=all in the
mkinitrd.conf -> initrd.img was 14mb and set it up in the grub with 
module /initrd....
on boot it loads the initrd like:
Loading ramdisk into ram .... done

but then NO MODULES in the initrd are being loaded by the kernel, though 
initrd support is in the kernel,
and the kernel states kernel panic (because no sata or raid modules are 
being loaded).


Second:
Built a kernel with sata support and everything and make 2.6-xen-build 
and 2.6-xen-install --->
Dom0 differs from xen on boot ...
saved a .config from the kernel , make mrproper, make dist, put .config 
in kernel path, make dist again...
-> xen stated failure in kernel package and asked me to run make mrproper...

so is this called stable or what ?


Greetz anyway,
Amin

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users