|
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] RE: [Xen-users] Ubuntu: DomU hangs on boot
I'm using the pae hypervisor from gutsy. I built my own dom0 and domU kernels, though On Mon, 2007-11-26 at 15:28 -0700, Allen Unrau wrote: > I managed to get Xen running with Ubuntu Gutsy dom0 and domU’s BUT > with many problems. In the end it was just too much hassle for my > tastes, so I switched to Debian Etch. > > > > > ______________________________________________________________________ > From: xen-users-bounces@xxxxxxxxxxxxxxxxxxx > [mailto:xen-users-bounces@xxxxxxxxxxxxxxxxxxx] On Behalf Of Allen > Fowler > Sent: Monday, November 26, 2007 3:45 PM > To: Allen Fowler; xen-users@xxxxxxxxxxxxxxxxxxx > Subject: Re: [Xen-users] Ubuntu: DomU hangs on boot > > > > > *bump* > > Has anyone been able to get Xen working from the Ubuntu Gutsy repos? > > Or, am I just doing something wrong? > > > > > ----- Original Message ---- > From: Allen Fowler <allen.fowler@xxxxxxxxx> > To: xen-users@xxxxxxxxxxxxxxxxxxx > Sent: Sunday, November 25, 2007 10:50:14 PM > Subject: Re: [Xen-users] Ubuntu: DomU hangs on boot > > > Mitch <mitchkelly@xxxxxxxxxxxxxx> wrote: > > It could be you ran out of ram, i see you only have 383, try reducing > the xen to use 64 and see how that goes, > > > > Mitch, > > Hmm.. OK i tried allocating 64MB of ram, but the results are the same. > > > Here is what xen list shows then: > ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ > Name ID Mem VCPUs State > Time(s) > Domain-0 0 239 1 r----- > 417.5 > xendomu 10 64 1 -b---- > 11.0 > ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ > > > > Also be quick in going to xm console xenname it could be > freezing on something when it boots > > > > I can see the backlog when I type xen console, I just can't type > anything there. See log attached below in original message. (Is that > what you meant?) > > > > > > ----- Original Message ----- > > > From: Allen Fowler > > > To: Allen Fowler ; xen-users@xxxxxxxxxxxxxxxxxxx > > > Sent: Monday, November 26, 2007 6:53 AM > > > Subject: Re: [Xen-users] Ubuntu: DomU hangs on boot > > > > > > To clarify: > > After I issue the "xm create xen_domu_name" command, > no errors are returned, and the "xm list" command > shows something like this: > > > ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ > Name ID Mem > VCPUs State Time(s) > Domain-0 0 239 > 1 r----- 279.0 > xendomu 7 128 > 1 -b---- 27.5 > ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ > > However, I am unable to ssh into the VM, and typing > anything at the "xm console" screen yields no > response. (Though, the "xm console" does show the > scroll back listed below.) > > Also, here is the output of "xm info": > > ~~~~~~~~~~~~~~~~~~~~~~~~~ > host : server2 > release : 2.6.22-14-xen > version : #1 SMP Mon Oct 15 00:35:38 > GMT 2007 > machine : i686 > nr_cpus : 1 > nr_nodes : 1 > sockets_per_node : 1 > cores_per_socket : 1 > threads_per_core : 1 > cpu_mhz : 996 > hw_caps : > 0383f9ff:00000000:00000000:00000040 > total_memory : 383 > free_memory : 0 > xen_major : 3 > xen_minor : 1 > xen_extra : .0 > xen_caps : xen-3.0-x86_32p > xen_scheduler : credit > xen_pagesize : 4096 > platform_params : virt_start=0xf5800000 > xen_changeset : unavailable > cc_compiler : gcc version 4.1.3 20070929 > (prerelease) (Ubuntu 4.1.2-16ubuntu2 > cc_compile_by : buildd > cc_compile_domain : buildd > cc_compile_date : Fri Oct 12 15:08:23 GMT 2007 > xend_config_format : 4 > ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ > > Thank you again... > > > Allen Fowler <allen.fowler@xxxxxxxxx> wrote: > > Hello, > > I followed the directions at: > > http://www.howtoforge.com/ubuntu-7.10-server-install-xen-from-ubuntu-repositories > > Dom0 boots fine. > > However, I can't seem to get any DomU to start. > > Any help would be appreciated. > > Thank you, > Allen > > Various outputs attached below: > > ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ > DomU config > ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ > # > # Configuration file for the Xen instance xendomu, > created > # by xen-tools 3.5 on Fri Nov 23 15:19:59 2007. > # > > # > # Kernel + memory size > # > kernel = '/boot/vmlinuz-2.6.22-14-xen' > ramdisk = '/boot/initrd.img-2.6.22-14-xen' > memory = '128' > > # > # Disk device(s). > # > root = '/dev/hda1 ro' > disk = > [ 'file:/home/xen/domains/xendomu/disk.img,hda1,w', > 'file:/home/xen/domains/xendomu/swap.img,hda2,w' ] > > # > # Hostname > # > name = 'xendomu' > > # > # Networking > # > vif = [ 'ip=10.0.0.71' ] > > # > # Behaviour > # > on_poweroff = 'destroy' > on_reboot = 'restart' > on_crash = 'restart' > > ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ > > ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ > xm dmesg > ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ > [SNIP] > (XEN) System RAM: 383MB (392572kB) > (XEN) Xen heap: 10MB (10276kB) > (XEN) Domain heap initialised: DMA width 32 bits > (XEN) PAE enabled, limit: 16 GB > (XEN) Local APIC disabled by BIOS -- you can enable it > with "lapic" > (XEN) Using scheduler: SMP Credit Scheduler (credit) > (XEN) Detected 996.791 MHz processor. > (XEN) CPU0: Intel Pentium III (Coppermine) stepping 0a > (XEN) Mapping cpu 0 to node 255 > (XEN) Platform timer is 1.193MHz PIT > (XEN) Brought up 1 CPUs > (XEN) *** LOADING DOMAIN 0 *** > (XEN) Xen kernel: 32-bit, PAE, lsb > (XEN) Dom0 kernel: 32-bit, PAE, lsb, paddr 0xc0100000 > -> 0xc04c0000 > (XEN) PHYSICAL MEMORY ARRANGEMENT: > (XEN) Dom0 alloc.: > 0000000014000000->0000000016000000 (80008 pages to be > allocated) > (XEN) VIRTUAL MEMORY ARRANGEMENT: > (XEN) Loaded kernel: c0100000->c04c0000 > (XEN) Init. ramdisk: c04c0000->c145e800 > (XEN) Phys-Mach map: c145f000->c14b5220 > (XEN) Start info: c14b6000->c14b646c > (XEN) Page tables: c14b7000->c14c8000 > (XEN) Boot stack: c14c8000->c14c9000 > (XEN) TOTAL: c0000000->c1800000 > (XEN) ENTRY ADDRESS: c0100000 > (XEN) Dom0 has maximum 1 VCPUs > (XEN) Initrd len 0xf9e800, start at 0xc04c0000 > (XEN) Scrubbing Free RAM: done. > (XEN) Xen trace buffers: disabled > (XEN) Std. Loglevel: Errors and warnings > (XEN) Guest Loglevel: Nothing (Rate-limited: Errors > and warnings) > (XEN) Xen is relinquishing VGA console. > (XEN) *** Serial input -> DOM0 (type \047CTRL-a\047 > three times to switch input to Xen). > ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ > > > ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ > xm console xendomu > ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ > [15785.652879] xen_mem: Initialising balloon driver. > [15785.660761] Setting mem allocation to 131072 kiB > [15785.661268] PCI: System does not support PCI > [15785.661371] PCI: System does not support PCI > [15785.661489] NET: Registered protocol family 8 > [15785.661541] NET: Registered protocol family 20 > [15785.662582] NET: Registered protocol family 2 > [15785.662767] Time: xen clocksource has been > installed. > [15785.704611] IP route cache hash table entries: 2048 > (order: 1, 8192 bytes) > [15785.704753] TCP established hash table entries: > 8192 (order: 4, 98304 bytes) > [15785.705029] TCP bind hash table entries: 8192 > (order: 4, 65536 bytes) > [15785.705237] TCP: Hash tables configured > (established 8192 bind 8192) > [15785.705252] TCP reno registered > [15785.734838] checking if image is initramfs... it is > [15785.973231] Freeing initrd memory: 15996k freed > [15785.974312] audit: initializing netlink socket > (disabled) > [15785.974572] audit(1196015716.968:1): initialized > [15785.980115] VFS: Disk quotas dquot_6.5.1 > [15785.980729] Dquot-cache hash table entries: 1024 > (order 0, 4096 bytes) > [15785.981277] io scheduler noop registered > [15785.981404] io scheduler anticipatory registered > [15785.981455] io scheduler deadline registered > [15785.981569] io scheduler cfq registered (default) > [15786.075774] Real Time Clock Driver v1.12ac > [15786.077525] RAMDISK driver initialized: 16 RAM > disks of 65536K size 1024 blocksize > [15786.078314] input: Macintosh mouse button emulation > as /class/input/input0 > [15786.078818] xencons_init: Initializing xen vfb; > pass xencons=tty to prevent this > [15786.079520] Xen virtual console successfully > installed as xvc0 > [15786.079866] Event-channel device installed. > [15786.147564] netfront: Initialising virtual ethernet > driver. > [15786.149571] PNP: No PS/2 controller found. Probing > ports directly. > [15786.150636] i8042.c: No controller found. > [15786.150879] mice: PS/2 mouse device common for all > mice > [15786.151222] TCP cubic registered > [15786.151276] NET: Registered protocol family 1 > [15786.151350] Using IPI No-Shortcut mode > [15786.152801] xen-vbd: registered block device major > 3 > [15786.152855] blkfront: hda1: barriers enabled > [15786.155045] blkfront: hda2: barriers enabled > [15786.163005] netfront: device eth0 has copying > receive path. > [15786.244504] XENBUS: Device with no driver: > device/console/0 > [15786.244975] Freeing unused kernel memory: 200k > freed > [15786.839976] AppArmor: AppArmor > initialized<5>audit(1196015717.836:2): type=1505 > info="AppArmor initialized" pid=992 > [15786.864141] fuse init (API version 7.8) > [15786.887322] Failure registering capabilities with > primary security module. > [15786.986664] thermal: Unknown symbol > acpi_processor_set_thermal_limit > ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ > > > > > > ______________________________________________________ > Never miss a thing. Make Yahoo your homepage. > _______________________________________________ > Xen-users mailing list > Xen-users@xxxxxxxxxxxxxxxxxxx > http://lists.xensource.com/xen-users > > > > > ______________________________________________________ > Be a better pen pal. Text or chat with friends inside > Yahoo! Mail. See how. > > _______________________________________________ > Xen-users mailing list > Xen-users@xxxxxxxxxxxxxxxxxxx > http://lists.xensource.com/xen-users > > No virus found in this incoming message. > Checked by AVG Free Edition. > Version: 7.5.503 / Virus Database: 269.16.6/1150 - > Release Date: 11/24/2007 5:58 PM > > > _______________________________________________ > Xen-users mailing list > Xen-users@xxxxxxxxxxxxxxxxxxx > http://lists.xensource.com/xen-users > > > > > > ______________________________________________________________________ > Be a better sports nut! Let your teams follow you with Yahoo Mobile. > Try it now. > > > > > > > > > ______________________________________________________________________ > Be a better pen pal. Text or chat with friends inside Yahoo! Mail. See > how. > > > _______________________________________________ > Xen-users mailing list > Xen-users@xxxxxxxxxxxxxxxxxxx > http://lists.xensource.com/xen-users Attachment:
signature.asc _______________________________________________ Xen-users mailing list Xen-users@xxxxxxxxxxxxxxxxxxx http://lists.xensource.com/xen-users
|
 |
Lists.xenproject.org is hosted with RackSpace, monitoring our |