Hi All,
I’m trying to setup the network on IBM xSeries 366
server (SuSE 10 SP1 – Xen virtualization).
But for bridges other than xenbr0, hardware address is displayed
as all 0’s.
Script used to create additional bridge –
#!/bin/sh
dir=$(dirname "$0")
"$dir/network-bridge" "$@" vifnum=0
netdev=eth0 bridge=xenbr0
"$dir/network-bridge" "$@" vifnum=2
netdev=eth2 bridge=xenbr2
xenbr0 Link encap:Ethernet HWaddr
FE:FF:FF:FF:FF:FF
inet6
addr: fe80::200:ff:fe00:0/64 Scope:Link
UP
BROADCAST RUNNING NOARP MTU:1500 Metric:1
RX
packets:461 errors:0 dropped:0 overruns:0 frame:0
TX
packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX
bytes:31409 (30.6 Kb) TX bytes:0 (0.0 b)
xenbr2 Link encap:Ethernet HWaddr
00:00:00:00:00:00
inet6
addr: fe80::200:ff:fe00:0/64 Scope:Link
UP
BROADCAST RUNNING NOARP MTU:1500 Metric:1
RX
packets:0 errors:0 dropped:0 overruns:0 frame:0
TX
packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX
bytes:0 (0.0 b) TX bytes:0 (0.0 b)
ibm366-61:/etc/xen/scripts # brctl show
bridge name bridge
id
STP enabled interfaces
xenbr0
8000.feffffffffff
no
vif0.0
peth0
xenbr2
8000.000000000000 no
ibm366-61:/etc/xen/scripts # ifconfig eth2
eth2 Link encap:Ethernet
HWaddr 00:0C:FC:00:24:0A
BROADCAST MULTICAST MTU:1500 Metric:1
RX
packets:0 errors:0 dropped:0 overruns:0 frame:0
TX
packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX
bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Interrupt:20
Can ideas / suggestions ?
Thanks
Mihir
