Xen project Mailing List

On Thu, Apr 24, 2008 at 3:58 AM, Ian Tobin <itobin@xxxxxxxxxxxxx> wrote:

Hi Todd,

Im not sure what other files to post but here is the whole of that network-bridge file. Im a bit puzzled why it has done this. The only change I made before compile was to set XEN_TARGET_X86_PAE ?= n in Config.mk as my CPU doesn't have PAE support.

http://pastebin.com/m29563680

thanks in advance

Ian

From: Todd Deshane [mailto:deshantm@xxxxxxxxx]
Sent: 24 April 2008 02:22

To: Ian Tobin
Cc: Xen-users@xxxxxxxxxxxxxxxxxxx
Subject: Re: [Xen-users] xend start error

Can you post the whole file and any other seemingly relevant files in a pastebin and send a link?

On Wed, Apr 23, 2008 at 7:04 PM, Ian Tobin <itobin@xxxxxxxxxxxxx> wrote:

Hi Todd,

Its Debian 3.1 and at the top it says #!/bin/bash

Thanks for getting back to me

Ian

From: Todd Deshane [mailto:deshantm@xxxxxxxxx]
Sent: 23 April 2008 23:54

To: Ian Tobin
Cc: Xen-users@xxxxxxxxxxxxxxxxxxx
Subject: Re: [Xen-users] xend start error

Hi Ian,

On Wed, Apr 23, 2008 at 6:38 PM, Ian Tobin <itobin@xxxxxxxxxxxxx> wrote:

Hi Todd,

I compiled it from source using my 3.0.4 config file as the basis. I got the source using mericual.

I havn't made any changes to the files.

Here is the line of 63

[[ "$rootfs" =~ "^nfs" ]] || [[ "$rootopts" =~ "_netdev" ]] && return 0 || return 1

}

What distro are you using?

at the top of the script does it have #!/bin/sh or #!/bin/bash ?

if /bin/sh, check what you /bin/sh symlink points to.

I am off to a meeting, but you could also try to make a simple test bash script to see if that line works.

Todd

Thanks

Ian

From: Todd Deshane [mailto:deshantm@xxxxxxxxx]
Sent: 23 April 2008 02:13
To: Ian Tobin
Cc: Xen-users@xxxxxxxxxxxxxxxxxxx
Subject: Re: [Xen-users] xend start error

Hi Ian,

On Tue, Apr 22, 2008 at 7:14 AM, Ian Tobin <itobin@xxxxxxxxxxxxx> wrote:

Hi,

Just installed 3.2 and when I run xend start I get this

/etc/xen/scripts/network-bridge: line 63: conditional binary operator expected

Any ideas?

Did you take a look at the network-bridge script? You could post the lines to the list if you need help analyzing.

I am guessing that it is either a change you made in your general configuration, or that one of the tools or packages you have is slightly off.

It is hard to tell without more information.

When you say you installed Xen 3.2, how did you install it, from where? What changes to configuration files did you make after installing it? Was it a fresh install or an upgrade?

Cheers,
Todd

Thanks

Ian

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users