Re: [Xen-users] DomU does not boot:

["Rick Wagner" <rick@xxxxxxxxxxxxxxxxx>]

The way I fixed this was to add

extra='xencons=tty'

to the DomU config file
Now I am on Debian 3.2.1 32bit built from source and domU created with
xen-tools

Hope it helps
Rick Wagner




> Hi,
>
> I have been stuck at this point for 2 weeks. My domU does not boot. It
> just shows this screen and stops:
>
> Xen virtual console successfully installed as xvc0
> Event-channel device installed.
> netfront: Initialising virtual ethernet driver.
> xen-vbd: registered block device major 8
> blkfront: sda1: barriers enabled
> Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
> ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx
> PNP: No PS/2 controller found. Probing ports directly.
> i8042.c: No controller found.
> mice: PS/2 mouse device common for all mice
> md: md driver 0.90.3 MAX_MD_DEVS=256, MD_SB_DISKS=27
> md: bitmap version 4.39
> NET: Registered protocol family 1
> NET: Registered protocol family 17
> Using IPI No-Shortcut mode
> vif vif-0: 2 parsing device/vif/0/mac
> blkfront: sda2: barriers enabled
> XENBUS: Device with no driver: device/console/0
> BIOS EDD facility v0.16 2004-Jun-25, 0 devices found
> EDD information not available.
> md: Autodetecting RAID arrays.
> md: autorun ...
> md: ... autorun DONE.
> EXT2-fs warning (device sda1): ext2_fill_super: mounting ext3 filesystem as
> ext2
> VFS: Mounted root (ext2 filesystem) readonly.
> Freeing unused kernel memory: 196k freed
>
>
> Mine is a xen 3.2.0 32 bit installation on FC8 again 32 bit.
>
> -Asim
>
> _______________________________________________
> Xen-users mailing list
> Xen-users@xxxxxxxxxxxxxxxxxxx
> http://lists.xensource.com/xen-users
>
> ______________________________________________________
> This email was pre-scanned by Spam Guardian
>



_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users