From:
xen-users-bounces@xxxxxxxxxxxxxxxxxxx
[mailto:xen-users-bounces@xxxxxxxxxxxxxxxxxxx] On Behalf Of you_bear zhou
Sent: woensdag 18 juni 2008 15:34
To: Ray Barnes
Cc: xen-users@xxxxxxxxxxxxxxxxxxx
Subject: Re: [Xen-users] Xenbr0
doesn't talk to outside
brctl show :
bridge name bridge
id STP
enabled interfaces
xenbr0
8000.feffffffffff
no
vif 9.0
it seems xenbr0 is started, any other suggestions?
On Tue, Jun 17, 2008 at 5:13 PM, you_bear zhou <youbear.zhou@xxxxxxxxx> wrote:
thank you for quick answer !
I set "bridge=xenbr0" in domU, but I didn't check "brctl
show"
I'll check it tomorrow ( the computer is not at hand right now :(
)
On 6/17/08, Ray
Barnes <tical.net@gmail.com> wrote:
I'm no expert on bridged networking under Xen (I only use routed
networking in production), but start by making sure "bridge=xenbr0"
is in your domU vif config file (make sure you have a vif setup too....), and
check the dom0 to make sure the bridge is bridging your domU to the physical
NIC using "brctl show".
Hi, all,
I installed xen 3.0.3 on Ubuntu 7.10, and I set up VM dapper using xen-tools.
Now, my VM can be boot successfully but without network.
I used wireshark and tcpdump to trace, I found that the vm sent requests to
xenbr0, but xenbr0 didn't send them out ! In dom0, I can't see any
request from domU.
In xend.conf, I use network-bridge and vif-bridge as default.
Maybe this problem is very simple, but as a beginner, it puzzled me a lot!
I do appreciate if someone can help me out. !
Best,
--
Fangfei Zhou
----------------------------------------------------
I have a dream, fly to the sky
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users
|
