[Xen-users] network-script don't start on boot

["Lucas Mocellin" <lucasmocellin@xxxxxxxxx>]

Hi,

I'm having trouble with the network-script.

I have 2 networks and I did a script to bridge both.
-rwxr-xr-x 1 root root  520 2008-08-03 15:28 network-bridge-eth0-eth1
cat network-bridge-eth0-eth1
# !/bin/sh
# network-xen-multi-bridge
# Exit if anything goes wrong
set -e

dir=$(dirname "$0")

# First arg is operation.
#shift
case $1 in
start)
        "$dir/network-bridge" "$@" netdev=eth0
        "$dir/network-bridge" "$@" netdev=eth1
        ;;
stop)
        #"$dir/network-bridge" "$@" bridge=peth0 netdev=eth0
        "$dir/network-bridge" "$@" netdev=eth1
        ;;
status)
        "$dir/network-bridge" "$@"
        ;;
*)
        echo 'Unknown command: ' ${OP}
        echo 'Valid commands are: start, stop, status'
        exit 1
        ;;
esac

If I start the script manually, all goes fine, but the script don't start at boot.

There is execution permission and are in xend-config.sxp

Anyboy has any idea?

thanks,

Lucas.

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users