Re: [Xen-users] Solaris 10

[jonr@xxxxxxxxxx]

Excellent! Thanks again Boris!

Jon

Quoting Boris Derzhavets <bderzhavets@xxxxxxxxx>:

> Jon,
>
> S10 HVM DomU would be 32-bit at Xen 3.3 Linux Dom0 (64-bit).
> Through my experience attempt to load amd64 solaris kernel
> always fails. S10 may be also installed in stub domain
> at Xen 3.3 Linux Dom0 (64-bit):-
>
> http://bderzhavets.wordpress.com/2008/09/27/getting-stubdom-working-on-xen-33-port-via-httpwwwgitcoderepoxen330-to-centos-52/
>
> However, having Solaris Nevada (say b98) in Dom0
> S10 (05/08) HVM will be installed in 64-bit mode via virt-install
> by default (and it will cause performance degradation).
> S10 (10/08) is supposed to be out in the mid of October.
> Sun planned this release to have PV drivers.
> Not sure would it work only at Nevada Dom0 or Linux Dom0 also.
> Actually, i am not sure would it work anywhere or no ?
>
>
>
> ----- Original Message ----
> From: "jonr@xxxxxxxxxx" <jonr@xxxxxxxxxx>
> To: "xen-users@xxxxxxxxxxxxxxxxxxx" <xen-users@xxxxxxxxxxxxxxxxxxx>
> Sent: Friday, October 3, 2008 8:10:57 PM
> Subject: Re: [Xen-users] Solaris 10
>
> Thank you Boris!
>
> I just needed to know if it worked before I kept smashing my head
> against a wall trying to make it work. Also, thanks for sharing your
> config file.
>
> One more question if you don't mind, does it have to be 64bit on a   
> 64bit dom0?
> Jon
>
>
> Quoting Boris Derzhavets <bderzhavets@xxxxxxxxx>:
>
> > I've installed S10 (05/08) in HVM DomU (via virt-install)
> > on Xen 3.3 CentOS 5.2 Dom0 ( port via http://www.gitco.de/repo/xen3.3.0).
> >  It also runs fine as HVM DomU at Xen 3.3 CentOS 5.2 Dom0
> > been built from source.
> >  name = "S10HVM"
> > builder = "hvm"
> > memory = "1024"
> > disk = ['phy:/dev/sdb7,ioemu:hda,w',
> > 'file:/etc/xen/disks/solar10.iso,hdc:cdrom,r']
> > vif = [ 'type=ioemu,bridge=eth(X)', ]
> > device_model = "/usr/lib64/xen/bin/qemu-dm"
> > kernel = "/usr/lib/xen/boot/hvmloader"
> > vnc=1
> > boot="d"
> > vcpus=1
> > serial = "pty" # enable serial console
> > on_reboot   = 'restart'
> > on_crash    = 'restart'
> >  It will also run at SNV98 Dom0 with no problems.
> >  ----- Original Message ----
> > From: "jonr@xxxxxxxxxx" <jonr@xxxxxxxxxx>
> > To: "xen-users@xxxxxxxxxxxxxxxxxxx" <xen-users@xxxxxxxxxxxxxxxxxxx>
> > Sent: Wednesday, October 1, 2008 11:56:55 PM
> > Subject: [Xen-users] Solaris 10
> >
> > Hello List,
> >
> > Has anybody gotten the x86 version of Solaris 10 running as a HVM
> > domu, not OpenSolaris.
> >
> > If so did you take notes or have a config file you'd like to share? :)
> >
> > Basically, I want to know if it is possible and if so were there any
> > gotcha's to look out for.
> >
> > Thanks for any info,
> >
> > Jon
> >
> >
> >
> > _______________________________________________
> > Xen-users mailing list
> > Xen-users@xxxxxxxxxxxxxxxxxxx
> > http://lists.xensource.com/xen-users
>
>
>
>
> _______________________________________________
> Xen-users mailing list
> Xen-users@xxxxxxxxxxxxxxxxxxx
> http://lists.xensource.com/xen-users




_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users