[Xen-users] domU does not fully boot

[Jon Rafkind <rafkind@xxxxxxxxxxx>]

I just started using xen and need some help getting going. I'm using 
xen-3.3. So far I've created two kernels by editing configs/Linux.mk so 
that I have 2.6.18.8-xen and 2.6.18-8-xenU. The xen kernel has some 
extra configuration options, the xenU kernel is the default config that 
comes with the xen distribution.
I'm booted into the xen dom0 kernel and have created a root disk for the 
domU machine. The bootup screen gets to the point where it says 
"Continue..." and doesn't get further. I tried using gdbserver-xen but 
the backtrace I see is useless hex addresses, I can't get any useful 
info from it. I'm not sure how to debug further. Can anyone provide a tip?
Here is the console from domU:

$ sudo xm console test
io scheduler cfq registered
RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
Xen virtual console successfully installed as xvc0                  
Event-channel device installed.                  
netfront: Initialising virtual ethernet driver.
i8042.c: No controller found.                 
mice: PS/2 mouse device common for all mice
TCP bic registered                        
NET: Registered protocol family 1
NET: Registered protocol family 17
Using IPI No-Shortcut mode       
xen-vbd: registered block device major 8
blkfront: sda2: barriers enabled       
XENBUS: Device with no driver: device/console/0
Freeing unused kernel memory: 140k freed      
kjournald starting.  Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
                                                 
 ***************************************************************
 ***************************************************************
 ** WARNING: Currently emulating unsupported memory accesses  **
 **          in /lib/tls glibc libraries. The emulation is    **
 **          slow. To ensure full performance you should      **
 **          install a 'xen-friendly' (nosegneg) version of   **
 **          the library, or disable tls support by executing **
 **          the following as root:                           **
 **          mv /lib/tls /lib/tls.disabled                    **
 ** Offending process: modprobe (pid=663)                     **
 ***************************************************************
 ***************************************************************
                                                               
Continuing...
           

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users