[Xen-users] eth2 instead of eth0.

[Mauro <mrsanna1@xxxxxxxxx>]

My network card is recognized as eth2 on my debian lenny system.
In xen-config.sxp I've changed the line (network-script
network-bridge) in (network-script 'network-bridge netdev=eth2'), then
I reboot the system.
Now ifconfig says :
eth2      Link encap:Ethernet  HWaddr 00:22:64:f5:65:ca
          inet addr:192.168.4.190  Bcast:192.168.5.255  Mask:255.255.254.0
          inet6 addr: fe80::222:64ff:fef5:65ca/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:32575 errors:0 dropped:0 overruns:0 frame:0
          TX packets:645 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:2370788 (2.2 MiB)  TX bytes:98233 (95.9 KiB)

lo        Link encap:Local Loopback
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:8 errors:0 dropped:0 overruns:0 frame:0
          TX packets:8 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:560 (560.0 B)  TX bytes:560 (560.0 B)

peth2     Link encap:Ethernet  HWaddr 00:22:64:f5:65:ca
          inet6 addr: fe80::222:64ff:fef5:65ca/64 Scope:Link
          UP BROADCAST RUNNING PROMISC MULTICAST  MTU:1500  Metric:1
          RX packets:58788 errors:0 dropped:0 overruns:0 frame:0
          TX packets:647 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:11586733 (11.0 MiB)  TX bytes:101373 (98.9 KiB)
          Interrupt:16 Memory:f8000000-f8012100

I don't have any vif interfaces.
Where I do wrong?

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users