Re: [Xen-users] network problem after boot Xen

[Mike Lovell <mike@xxxxxxxxxxxx>]

Gra zeus wrote:

Hello,

I installed Xen 3.4.0 yesterday and managed to boot it up. When I boot my machine with xen kernel I can't find my eth0. I tried ifconfig  but it return only loopback interface.

Anyone experienced this before? Do I need to install something to get network card to work?

///////////// when boot with Xen kernel

lo        Link encap:Local Loopback  

          inet addr:127.0.0.1  Mask:255.0.0.0

          inet6 addr: ::1/128 Scope:Host

          UP LOOPBACK RUNNING  MTU:16436  Metric:1

          RX packets:1334 errors:0 dropped:0 overruns:0 frame:0

          TX packets:1334 errors:0 dropped:0 overruns:0 carrier:0

          collisions:0 txqueuelen:0 

          RX bytes:87408 (85.3 KiB)  TX bytes:87408 (85.3 KiB)

thx,

gra

Do a `ls /sys/class/net/`. Does it show anything besides lo in that directory? If not, then it is probably that the dom0 kernel you are booting does not have the driver for the particular network card that you have. If there is something besides lo, can you do an ifconfig on an interface named by what is listed there and get networking up?

Hopefully that gives you some direction.

mike

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users