On Sat, Apr 10, 2010 at 8:00 AM, Tapas Mishra
<mightydreams@xxxxxxxxx> wrote:
I do an ifconfig but at the last of it there is no bridge name
have a look at it I have installed all the things myself.
As Xen wiki page says the default bridge should be xen-br0 in the last
output of ifconfig it is not there
it is Xen-3.2.1 default name of bridge as they are saying should be
the same as default ethernet interface but that is xen-3.3 read point
number 6.So this is not the exact case with me.Where is the difference
occuring.
Here is
http://wiki.xensource.com/xenwiki/XenNetworking
DDDE:~# ifconfig
eth2 Â Â ÂLink encap:Ethernet ÂHWaddr 00:26:b9:82:42:38
    Âinet addr:192.1.100.12 ÂBcast:192.1..255 ÂMask:255.255.0.0
    Âinet6 addr: fe80::226:b9ff:fe82:4238/64 Scope:Link
    ÂUP BROADCAST RUNNING MULTICAST ÂMTU:1500 ÂMetric:1
    ÂRX packets:573 errors:0 dropped:0 overruns:0 frame:0
    ÂTX packets:172 errors:0 dropped:0 overruns:0 carrier:0
    Âcollisions:0 txqueuelen:0
    ÂRX bytes:215986 (210.9 KiB) ÂTX bytes:20257 (19.7 KiB)
--
Tapas
_______________________________________________
Check the output of brctl show. I'd almost bet your bridge is eth2.
Grant McWilliams
