[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Xen-users] lots of cycles in i/o wait state



Hi Folks,

I've been doing some experimenting to see how far I can push some old hardware into a virtualized environment - partially to see how much use I can get out of the hardware, and partially to learn more about the behavior of, and interactions between, software RAID, LVM, DRBD, and Xen.

Basic configuration:

- two machines, 4 disk drives each, two 1G ethernet ports (1 each to the outside world, 1 each as a cross-connect)
- each machine runs Xen 3 on top of Debian Lenny (the basic install)
- very basic Dom0s - just running the hypervisor and i/o (including disk management)
---- software RAID6 (md)
---- LVM
---- DRBD
---- heartbeat to provide some failure migration
- dom0, on each machine, runs directly on md RAID volumes (RAID1 for boot, RAID6 for root and swap)
- each Xen VM uses 2 DRBD volumes - one for root, one for swap
- one of the VMs has a third volume, used for backup copies of files

One domU, on one machine, runs a medium volume mail/list server. This used to run non-virtualized on one of the machines, and I moved it into a domU. Before virtualization, everything just hummed along (98% idle time as reported by top). Virtualized, the machine is mostly idle, but now top reports a lot of i/o wait time, usually in the 20-25% range).

As I've started experimenting with adding additional domUs, in various configurations, I've found that my mail server can get into a state where it's spending almost all of its cycles in an i/o wait state (95% and higher as reported by top). This is particularly noticeable when I run a backup job (essentially a large tar job that reads from the root volume and writes to the backup volume). The domU grinds to halt.

So I've been trying to track down the bottlenecks.

At first, I thought this was probably a function of pushing my disk stack beyond reasonable limits - what with multiple domUs on top of DRBD volumes, on top of LVM volumes, on top of software RAID6 (md). I figured I was seeing a lot of disk churning.

But... after running some disk benchmarks, what I'm seeing is something else:

- I took one machine, turned off all the domUs, and turned off DRBD
- I ran a disk benchmark (bonnie++) on dom0, which reported 50MB/sec to 90MB/sec of throughput depending on the test (not exactly sure what this means, but it's a baseline) - I then brought up DRBD and various combinations of domUs, and ran the benchmark in various places - the most interesting result, running in the same domU as the mail server: 34M-60M depending on the test (not much degredation from running directly on the RAID volume - but.... while running, the benchmark, the baseline i/o wait percentage jumps from 25% to the 70-90% range

So... the question becomes, if it's not disk churning, what's causing all those i/o wait cycles? I'm starting to think it might involve buffering or other interactions in the hypervisor.

Any thoughts or suggestions regarding diagnostics and/or tuning? (Other than "throw hardware at it" of course :-).

Thanks very much,

Miles Fidelman





_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users


 


Rackspace

Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.