[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [Xen-users] Xen Client won't start after reboot (when upgradeCentOS 5.4 to 5.5)

  • To: "Wendy William" <kotakomputer@xxxxxxxxx>, <xen-users@xxxxxxxxxxxxxxxxxxx>
  • From: "James Harper" <james.harper@xxxxxxxxxxxxxxxx>
  • Date: Mon, 14 Jun 2010 10:36:16 +1000
  • Cc:
  • Delivery-date: Sun, 13 Jun 2010 17:37:37 -0700
  • List-id: Xen user discussion <xen-users.lists.xensource.com>
  • Thread-index: AcsLRxDUGnscJqOwTaKFKxoNcM8wcgAEhT2A
  • Thread-topic: [Xen-users] Xen Client won't start after reboot (when upgradeCentOS 5.4 to 5.5)

> > Now, Dom-U can boot  (thanks!) but I still can not PING from Dom-U.
> > Please  advise.
> I found that peth0 is missing when I run ifconfig. This happen after I
> update CentOS 5.4 to 5.5
> Any idea how to enable again peth0?

Under Debian, I just set up my bridges in /etc/network/interfaces (no
sure if CentOS uses the same config method), and then tell xend not to
make the bridge by commenting out the line that says "(network-script

So in your case, I would comment out the config line, then reboot to
undo whatever funky stuff the xend network-bridge stuff does, make sure
eth0 is working, then set up a bridge that includes eth0 and put your IP
address on the bridge.


Xen-users mailing list



Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.