[Xen-users] xend start (not building br0 or vif interfaces)

["Horton, Steve - IS" <Steve.Horton@xxxxxxx>]

I've just gotten xen-4.0.1-rc4-pre on top of Ubuntu 10.04 using the  2.6.32.15 
kernel source installed and booting into Dom0 thanks to you guys!

I was under the impression that xend would setup at least a basic bridge 
interface and some vif interfaces automaticlly.. I don't get any of that. And 
when I try to start xend manually after reboot I get:
ifdown: interface eth0 not configured
RTNTELINK answers: Device or resource busy

Not sure what's going on.
Thanks,
-S

________________________________
This e-mail and any files transmitted with it may be proprietary and are 
intended solely for the use of the individual or entity to whom they are 
addressed. If you have received this e-mail in error please notify the sender.
Please note that any views or opinions presented in this e-mail are solely 
those of the author and do not necessarily represent those of ITT Corporation. 
The recipient should check this e-mail and any attachments for the presence of 
viruses. ITT accepts no liability for any damage caused by any virus 
transmitted by this e-mail.

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users