[Xen-users] RE: XCP 0.5 - dom0 vcpus/RAM settings not working

["Joe Linoff" <jlinoff@xxxxxxxxxx>]

Hi Dante:

Thank you for your suggestions. I tried them but I am still seeing 477MB
of RAM and 1 cpu after re-installation. Here are the settings:

  append xenserver/xen.gz dom0_mem=2048M dom0_max_vcpus=2 ...

Can you suggest a way to debug this?

Cheers,

Joe


-----Original Message-----
From: Dante Cinco [mailto:dantecinco@xxxxxxxxx] 
Sent: Wednesday, December 01, 2010 10:28 AM
To: xen-users@xxxxxxxxxxxxxxxxxxx; Joe Linoff
Subject: RE: XCP 0.5 - dom0 vcpus/RAM settings not working

You need to change dom0_vcpus_max to dom0_max_vcpus.

If you want 2GB RAM, use dom0_mem=2048M.

Dante



From: xen-users-bounces@xxxxxxxxxxxxxxxxxxx
[mailto:xen-users-bounces@xxxxxxxxxxxxxxxxxxx] On Behalf Of Joe Linoff
Sent: Wednesday, December 01, 2010 10:01 AM
To: xen-users@xxxxxxxxxxxxxxxxxxx
Cc: Joe Linoff
Subject: [Xen-users] XCP 0.5 - dom0 vcpus/RAM settings not working

Hi Folks:

What am I doing wrong? How do I configure my dom0 to have 2 vcpus and
2GB RAM?

I am trying to configure my dom0 to have 2 vcpus and 2GB of RAM. Here
are my config settings (pxlinux.cfg/default):

kernel mboot.c32
append xenserver/xen.gz dom0_mem=2097512 dom0_vcpus_max=2
dom0_vcpus_pin com1=115200,8n1 console=com1,tty --- xenserver/vmlinux
...

Everything installs correctly but when I log into dom0 and look at
/proc/cpuinfo there is only processor. Similarly, when I look
/proc/meminfo I only see 477MB.

Cheers,

Joe

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users