Re: [Xen-users] bridge and dhcpcd

[Alexandre Kouznetsov <alk@xxxxxxxxxx>]

Hello.

Casey asked for the right additional data. Additional output of the 
following commands might help as well:
xm list
brctl show

Double check you are plugging your cable modem to the right 
interface/network/VLAN.

El 06/05/13 15:19, jacek burghardt escribió:
> I had made an attempt to install pfsense under xen. The biggest issue
> I had run is that if i bridge network interface that has cable modem
> there is no way for virtual interface to obtain ip address. I wonder
> what am I doing wrong?
If your modem is set into bridged mode, some ISP's requires you to clone 
it's MAC address on the client device, that is the VM.
Not sure about dhcp client functionality, but it's known the dhcp server 
does not works well unless you disable offload capability on your 
virtualized network card, within DomU:
"ethtool -K ETHDEV tx off" usually is enough.

Try to sniff your bridge using tcpdump on Dom0, to see what goes wrong 
on the DHCP negotiation.
Greetings.

--
Alexandre Kouznetsov


_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxx
http://lists.xen.org/xen-users