Re: [Xen-users] NAT mode in Xen

[Jan Hejl <jh@xxxxxxxxxx>]

xl is officialy default since Xen 4.2 and i've seen lot of people using xm toolstack thanks to laziness, lack of time to upgrade or many howtos which describe Xen setup with xm.

Dne 29.5.2013 11:22, Yeonki Choi napsal(a):

xl has been the default toolstack since 4.1. But you should use xm in the older version than 4.1,Â

Yeonki Choi

Sent from my iPad

2013. 5. 29. ìí 6:08 "Jan Hejl" <jh@xxxxxxxxxx> ìì:

Another question? What version of Xen you use - 4.1+ or older? And what toolstack xm or xl?

Dne 29.5.2013 06:43, Jaya Dhanesh napsal(a):

I have worked on VB and there is a commands which will take care of assigning ip address to the interfaces in VMs and also configure the default route.

VBoxManage modifyvm "VM name" --natnet1 "nw_addr/mask"

This will assign IP address from the nw_addr and a default route as nw_addr.2. How do I achieve this in Xen?

Thanks,
Dhanesh.

On 05/24/2013 05:59 PM, Jan Hejl wrote:

Hi Jaya,

take a look here http://wiki.kartbuilding.net/index.php/Xen_Networking#Routed_Networking_with_NAT_2

Jan

Dne 24.5.2013 14:17, Jaya Dhanesh napsal(a):

Hi,

I need to have a group of DomUs behind a NAT. The ip address is also fixed for the DomU.
The default gateway will be through Dom0.
How do I do this on Xen?

Thanks,
Dhanesh.

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxx
http://lists.xen.org/xen-users

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxx
http://lists.xen.org/xen-users

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxx
http://lists.xen.org/xen-users

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxx
http://lists.xen.org/xen-users

Attachment: smime.p7s
Description: Elektronicky podpis S/MIME

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxx
http://lists.xen.org/xen-users