Re: [Embedded-pv-devel] [PATCH RFC 00/18] System adjustment to customer needs.

[Meng Xu <mengxu@xxxxxxxxxxxxx>]

On Thu, May 19, 2016 at 5:53 PM, Andrii Anisov
<andrii.anisov@xxxxxxxxxxxxxxx> wrote:
> Meng,
>

Hi Andrii,

Thank you very much for your explanation about the use case in previous email!

>>> If the board is not supported by Xen, can we say Xen will support the
>>> board with the warkaround?
>
> I would not say boards are supported by XEN (except earlyprintk).
> Rather architectures are supported in general, and SoC's are supported
> in architecture implementation defined deviations (i.e. SMMU absence).

Yes. I searched around for the "Jacinto 6" Automotive processor.[1]
It uses Cortex A15 processor...
However, I tried the Arndale Octo board two years ago
(http://www.arndaleboard.org/wiki/index.php/Main_Page). From my
previous experience, the board may not be supported by Xen even though
the processor it uses has virtualization extension.. :-(
That's why I asked if the board itself can run Xen. If the board can
run Xen, I would like to buy one and try it out. :-)

[1] http://www.ti.com/lit/ds/symlink/dra746.pdf

Thanks and Best Regards,

Meng
-----------
Meng Xu
PhD Student in Computer and Information Science
University of Pennsylvania
http://www.cis.upenn.edu/~mengxu/

_______________________________________________
Embedded-pv-devel mailing list
Embedded-pv-devel@xxxxxxxxxxxxxxxxxxxx
http://lists.xenproject.org/cgi-bin/mailman/listinfo/embedded-pv-devel