Re: [MirageOS-devel] Mirage ARM port

[Anil Madhavapeddy <anil@xxxxxxxxxx>]

On 1 May 2014, at 22:39, Anil Madhavapeddy <anil@xxxxxxxxxx> wrote:
> 
> I've started scripting up these notes so we can publish an SDcard
> image.  An early version is up at: 
> 
> https://github.com/mirage/xen-arm-builder
> 
> $ make clone
> $ make build
> $ make cubie.tar
> 
> ...will clone all the relevant repositories and build a sparse
> tarfile of Xen/uboot/Linux dom0 with Ubuntu Trusty (linaro/linaro
> is the login).
> 
> Not heavily tested at all, but should be a good base to customise
> the dom0 for Mirage so it's an out-of-the-box development environment
> for a Cubie2/3.
> 

An update: I've pushed support for the Cubieboard2 and Cubietruck
into the https://github.com/mirage/xen-arm-builder, and the resulting
dom0 now starts up with networking and the OCaml packages all 
installed to have a nice development environment.

If someone else with a Cubie wants to try it out, this is a good
time.  Just grab an Ubuntu 14.04 container or machine, run the
above commands, and dd the cubie.img onto an SDcard.  You can ssh
into the Cubie with username/password "linaro" and alter it.  No
serial console should be required now unless something goes wrong.

I did a quick test of MiniOS and that boots fine, and will give
FreeBSD a quick spin tomorrow.  Should be all set for Mirage on
there now.

-anil


_______________________________________________
MirageOS-devel mailing list
MirageOS-devel@xxxxxxxxxxxxxxxxxxxx
http://lists.xenproject.org/cgi-bin/mailman/listinfo/mirageos-devel