Following the installation guide.
The instructions are very clear and the ARM installation Guide leaves nothing to the imagination so I think I have it all setup correctly.
I connected the associated labeled power plugs to the associated boards
I configured a router to reserve an IP for 00:04:A3:48:D6:E6
I connected the Router LAN port 1 to RJ45-PDU
I connected the USB Cable from the computer to the ARM Crate USB0 Serial port
I connected the computer serial DB9 to the DB9 on the Metrocentre /Arndale board
I connected and Router LAN port 4 to an RJ45 cable from the router to the RJ45 port on the Metrocentre /Arndale board
I applied power to the POWER IEC Port
The Crate powered up and the disk lights and fans are running
I attempted to do the “grep” command but got no response from the board
I attempted to browse to the PDU (in this case 192.168.100.150) No connection
There are no RJ45 connection or link lights on the Metrocentre board.
I attempted to ping 192.168.100.150 but got no response.
At this point I need some help. I will call you when I get in this morning. I am going to call it a night.
I could configure the DCHP server to only have 4 addresses and try each one to see if I am getting a response, but if the MAC address is correct the reserved IP should be the one the ARM Crate is using at the PDU Port.
Paul L. George
President
PLG Enterprises, Inc.
All-Net Computer Solutions
42 East Main Street
Westboro, MA 01581
Office 508-898-9057
Cell: 508-450-9332
pgeorge@xxxxxxxxxx
