[Xen-devel] adding more than one disk.

["Ronald G. Minnich" <rminnich@xxxxxxxx>]

If I set up my xen file as follows:
disk = [ 'phy:loop0,loop0,w', 'phy:loop1,loop1,w']

I realize I should USTL but it seemed to me I should expect blkif changed 
messages for each vbd. I'm only getting the messages once. 

i.e. I see this:
===========> blkif_status_change to 1
===========> blkif_status_change to 2
===========> evtchn for blkif is 3
====> enable disk interrupt
=========> controller connected

For the first disk, and that's it. Shouldn't I see two of these sets of 
messages, one for each disk? 

Is my expectation wrong or is something else going on that I missed?

thanks

ron
p.s. I actually now have two plan 9/xen users out there ... 2 more than I 
had a month ago. So a month ago there was one, now 3 ... at this rate we 
should take over the planet in no time.


-------------------------------------------------------
SF email is sponsored by - The IT Product Guide
Read honest & candid reviews on hundreds of IT Products from real users.
Discover which products truly live up to the hype. Start reading now.
http://ads.osdn.com/?ad_id=6595&alloc_id=14396&op=click
_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxxxx
https://lists.sourceforge.net/lists/listinfo/xen-devel