Hi Keir, Ian,
I built PAE Xen with the default config, and it is not
booting. Log is bellow. If I replace the linux-defconfig_xen_x86_32 file with
the linux-defconfig_xen0_x86_32 before building then dom0 is able to boot and
see more than 4Gig memory. This looks like a dom0 kernel config issue. Do you
care PAE dom0 for 3.0.2 with the default config? Is anybody working on this?
IP route cache hash table entries: 262144 (order: 8, 1048576
bytes)
TCP established hash table entries: 524288 (order: 10,
4194304 bytes)
TCP bind hash table entries: 65536 (order: 7, 524288 bytes)
TCP: Hash tables configured (established 524288 bind 65536)
TCP reno
registered
NET: Registered protocol family 8
NET: Registered protocol family 20
Using IPI No-Shortcut mode
Freeing unused kernel memory: 172k freed
scsi_mod: no version for "struct_module" found:
kernel tainted.
SCSI subsystem initialized
ACPI: PCI Interrupt 0000:00:1f.2[A] -> GSI 18 (level,
low) -> IRQ 17
ata1: SATA max UDMA/133 cmd 0x0 ctl 0xC402 bmdma 0xBC00 irq
17
ata2: SATA max UDMA/133 cmd 0x0 ctl 0xC002 bmdma 0xBC08 irq
17
ata1: dev 0 ATA-6, max UDMA/133, 312581808 sectors: LBA48
ata1: dev 0 configured for UDMA/133
scsi0 : ata_piix
ATA: abnormal status 0x7F on port 0xC087
scsi1 : ata_piix
Vendor:
ATA Model:
ST3160023AS Rev: 3.00
Type:
Direct-Access
ANSI SCSI revision: 05
SCSI device sda: 312581808 512-byte hdwr sectors (160042 MB)
sda: Write Protect is off
SCSI device sda: drive cache: write back
SCSI device sda: 312581808 512-byte hdwr sectors (160042 MB)
sda: Write Protect is off
SCSI device sda: drive cache: write back
sda: unknown partition table
sd 0:0:0:0: Attached scsi disk sda
Kernel panic - not syncing: Attempted to kill init!
(XEN) Domain 0 crashed: rebooting machine in 5 seconds.
