Re: [Xen-devel] PAE mode mismatch in Xen (xen=no Dom0=yes)

[pak333@xxxxxxxxxxx]

Thanks, I just tried this and it gives me a bunch of errors

 

- Padma

 

 

 

> -------------- Original message -------------- 
> From: Anthony Liguori <aliguori@xxxxxxxxxx> 
>
> > You need to rebuild Xen (the hypervisor) with pae support. 
> > 
> > I believe it's something like make pae=yes 
> > 
> > Regards, 
> > 
> > Anthony Liguori 
> > 
> > pak333@xxxxxxxxxxx wrote: 
> > > Hi, 
> > > 
> > > I just added 32GB memory in my system and wanted Xen to see that 
> > > memory, so enabled PAE in xen0 and XenU. I did a make menuconfig in 
> > > xen0 and xenU, then did a make in xen-unstable and a make install. 
> > > 
> > > Whilebooting this kernel, I get the above error PAE mode mismatch. I 
> > > looked under xen/include/asm-x86/processor.h has #define X86_CR4_PAE 
> > > defined and so does cpufeature.h have this defined. #define 
> > > X86_FEATURE_PAE 
> > &g
> t; 
> > > What else should I have done to enable a PAE enabled Xen kernel. I am 
> > > using xen 3.0.0 (xen-unstable) and cannot move to 3.02 due to 
> > > xenoprofile not ready there 
> > > 
> > > Thanks 
> > > - Padma 
> > > ------------------------------------------------------------------------ 
> > > 
> > > _______________________________________________ 
> > > Xen-devel mailing list 
> > > Xen-devel@xxxxxxxxxxxxxxxxxxx 
> > > http://lists.xensource.com/xen-devel 
> > > 
> > 
> > 
> > _______________________________________________ 
> > Xen-devel mailing list 
> > Xen-devel@xxxxxxxxxxxxxxxxxxx 
> > http://lists.xensource.com/xen-devel 

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel