Re: [Xen-devel] Networking in dom0

[Keir Fraser <Keir.Fraser@xxxxxxxxxxxx>]

On 22 May 2006, at 20:50, Carb, Brian A wrote:

> Hello,
>  
> I'm running xen-unstable, changeset 10058, on sles10RC1 - x86_64. When 
> I build xen-unstable, boot dom0, and type ifconfig, I only see 2 
> network interfaces - eth0 and lo. The xen interfaces such as peth0 and 
> xenbr0 do not show up. However, if I edit /etc/xen/xend-config.sxp and 
> change the (network-script network-bridge) statement to 
> (network-script 'network-bridge vifnum=0') and restart xend, the xen 
> network interfaces are configured and show up when I type ifconfig. I 
> was under the impression from the documentation that default values 
> are used in the network-bridge script, and that no parameters need to 
> be specified.  Can someone clarify this?

That's supposed to be the case, yes (ie. yes, it should usually work 
out of the box).
 -- Keir


> brian carb
> unisys cmp technology lab
> malvern, pa
> brian.carb@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> Xen-devel mailing list
> Xen-devel@xxxxxxxxxxxxxxxxxxx
> http://lists.xensource.com/xen-devel

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel