RE: [Xen-devel] svm vmexit action sequence

["Jan Beulich" <jbeulich@xxxxxxxxxx>]

One more question: both variants have HVM_SAVE_ALL_NOSEGREGS do a
forced reset of eflags/rflags - what is this needed for? #VMEXIT supposedly
restores them. Jan 

>>> "Petersson, Mats" <Mats.Petersson@xxxxxxx> 10.05.07 18:12 >>>


> -----Original Message-----
> From: xen-devel-bounces@xxxxxxxxxxxxxxxxxxx 
> [mailto:xen-devel-bounces@xxxxxxxxxxxxxxxxxxx] On Behalf Of 
> Jan Beulich
> Sent: 10 May 2007 17:02
> To: xen-devel@xxxxxxxxxxxxxxxxxxx 
> Subject: [Xen-devel] svm vmexit action sequence
> 
> Is there any particular reason why on 32-bits the order is VMLOAD then
> HVM_SAVE_ALL_NOSEGREGS, while on 64-bits its is the other way around?
> Trying to put in the saving of EAX, I could save a 
> GET_CURRENT() on 32-bits
> if I could order things the same way as on 64-bits.

I don't see any reason why these shouldn't be the same (or at least as
similar as possible).
> 
> Also, both versions seem to have a redundant GET_CURRENT() right after
> the clgi/sti sequence - again, is there a particular reason for this?

No reason as far as I can tell. Assuming rbx (in 64-bit case) isn't
clobbered by called functions, that is. I can't remember for 64-bit if
rbx is "safe" or not. [It certainly is safe in 32-bit]. 

Thanks for spotting these things.

--
Mats
> 
> Thanks, Jan
> 
> 
> 
> _______________________________________________
> Xen-devel mailing list
> Xen-devel@xxxxxxxxxxxxxxxxxxx 
> http://lists.xensource.com/xen-devel 
> 
> 
> 




_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel