Re: [Xen-devel] Re: console changes in cs153 on 2.6.18-xen

[Stefan Berger <stefanb@xxxxxxxxxx>]

xen-devel-bounces@xxxxxxxxxxxxxxxxxxx wrote on 09/05/2007
01:09:36 PM:

> Remove console=ttyS0 from your command line, if you have it. You can
> replace it with console=xvc0.

I actually had console=tty0 on my machines before
and this worked fine. Now using console=xvc0 I see the (Xen) outputs with
the last line that Xen is relinquishing the VGA console and then no output
during the boot process. The blinking cursor moves into the upper left
corner after Xen is done and at some point during the boot process the
Xen output becomes mouse-selectable. Then comes the login prompt. I am
surprise that no one else seeing this.

   Stefan

> 
>  -- Keir
> 
> On 4/9/07 19:16, "Stefan Berger" <stefanb@xxxxxxxxxx>
wrote:

> 
> Hello! 
> 
>   Since cs153 to the 2.6.18-xen kernel Linux does not print out
any 
> information while booting nor does it offer a console for login on.
> Do I have to pass boot command line parameters to see the output?
> 
> Thanks. 
>    Stefan 

> _______________________________________________
> Xen-devel mailing list
> Xen-devel@xxxxxxxxxxxxxxxxxxx
> http://lists.xensource.com/xen-devel
_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel