Re: [Xen-devel] No console with xen-3.2

[Stefan Berger <stefanb@xxxxxxxxxx>]

Are you using the tip of the tree? Could
it be a crash? I see it crashing (tip) and only the cursor blinking in
the upper left corner.

   Stefan

xen-devel-bounces@xxxxxxxxxxxxxxxxxxx wrote on 11/13/2007
10:18:53 AM:

> No output at all.
> 
> On Nov 13, 2007 10:10 AM, Keir Fraser <Keir.Fraser@xxxxxxxxxxxx>
wrote:
> > Do you mean you cannot type input at the vga console, or do you
mean there
> > is no output at all? Does output from Xen appear, but not from
dom0?
> >
> >  -- Keir
> >
> >
> > On 13/11/07 13:40, "Chuck Short" <zulcss@xxxxxxxxx>
wrote:
> >
> > > Hi,
> > >
> > > I installed Xen-3.2 last night and setup the grub.conf and
kernel as
> > > usual. However, when I rebooted I did not get an console
input when
> > > booting the dom0. I tried adding the console=vga to my grub.conf
as
> > > shown below:
> > >
> > > title xen-3.2
> > > root (hd0,0)
> > > kernel /boot/xen-3.2.gz console=vga
> > > module  /boot/vmlinuz-2.6.18.8
> > > root=UUID=7373696f-c367-4a6a-b198-17e593508cc8 ro console=tty0
> > > module /boot/xen-2.6.18
> > > quiet
> > >
> > > I am not sure where to go from here.
> > >
> > > Thanks
> > > chuck
> > >
> > > _______________________________________________
> > > Xen-devel mailing list
> > > Xen-devel@xxxxxxxxxxxxxxxxxxx
> > > http://lists.xensource.com/xen-devel
> >
> >
> >
> 
> _______________________________________________
> Xen-devel mailing list
> Xen-devel@xxxxxxxxxxxxxxxxxxx
> http://lists.xensource.com/xen-devel
_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel