Re: [Xen-devel] [PATCH] Add a timer mode that disables pending missed ticks

[Dave Winchell <dwinchell@xxxxxxxxxxxxxxx>]

Keir,

I'll run the I/O and idle tests you suggested.
Since the tests will be run in the evenings, they won't be
completed until the end of the week.

Below is the table of tests updated with the weekend SYNC with cpu load 
test,
where the error was less than .01% for both linux guests.

> I'm a bit worried about any unwanted side effects of the SYNC+run_timer
> approach -- e.g., whether timer wakeups will cause higher system-wide CPU
> contention.


I agree. If the SYNC model turns out to be desirable from an accuracy
standpoint, then the significance of the additional wakeups should
characterized.

Regards,
Dave


Date     Duration       Protocol                 sles, rhat 
error                      load
11/07  23 hrs 40 min     ASYNC         -4.96 sec, +4.42 sec    -.006%,  
+.005%         cpu
11/09   3 hrs 19 min     ASYNC          -.13 sec, +1.44 sec,   -.001%,  
+.012%         cpu
11/08   2 hrs 21 min      SYNC          -.80 sec,  -.34 sec,   -.009%,  
-.004%         cpu
11/08   1 hr  25 min      SYNC          -.24 sec,  -.26 sec,   -.005%,  
-.005%         cpu
11/12  65 hrs 40 min      SYNC        -18    sec, -8    sec,   -.008%,  
-.003%         cpu
11/08         28 min     MIXED          -.75 sec,  -.67 sec    -.045%,  
-.040%         cpu
11/08  15 hrs 39 min     MIXED        -19.   sec,-17.4  sec,   -.034%,  
-.031%         cpu

Keir Fraser wrote:

> On 9/11/07 19:22, "Dave Winchell" <dwinchell@xxxxxxxxxxxxxxx> wrote:
>
>  
>
> > Since I had a high error (~.03%) for the ASYNC method a couple of days ago,
> > I ran another ASYNC test. I think there may have been something
> > wrong with the code I used a couple of days ago for ASYNC. It may have been
> > missing the immediate delivery of interrupt after context switch in.
> >
> > My results indicate that either SYNC or ASYNC give acceptable accuracy,
> > each running consistently around or under .01%. MIXED has a fairly high
> > error of
> > greater than .03%. Probably too close to .05% ntp threshold for comfort.
> > I don't have an overnight run with SYNC. I plan to leave SYNC running
> > over the weekend. If you'd rather I can leave MIXED running instead.
> >
> > It may be too early to pick the protocol and I can run more overnight tests
> > next week.
> >    
> I'm a bit worried about any unwanted side effects of the SYNC+run_timer
> approach -- e.g., whether timer wakeups will cause higher system-wide CPU
> contention. I find it easier to think through the implications of ASYNC. I'm
> surprised that MIXED loses time, and is less accurate than ASYNC. Perhaps it
> delivers more timer interrupts than the other approaches, and each interrupt
> event causes a small accumulated error?
>
> Overall I would consider MIXED and ASYNC as favourites and if the latter is
> actually more accurate then I can simply revert the changeset that
> implemented MIXED.
>
> Perhaps rather than running more of the same workloads you could try idle
> VCPUs and I/O bound VCPUs (e.g., repeated large disc reads to /dev/null)? We
> don't have any data on workloads that aren't CPU bound, so that's really an
> obvious place to put any further effort imo.
>
> -- Keir
>
>
>  

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel