[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Xen-devel] Re: [PATCH] ioemu-remote: ACPI S3 state wake up



I think Jean's original and only problem was with the s3_resume_flag.

 -- Keir

On 24/7/08 13:54, "Trolle Selander" <trolle.selander@xxxxxxxxx> wrote:

Was this s3_resume_flag the _only_ thing that needed to be in r/w space, or was that just the only thing in the rombios range? That is - should we revert to the original code, or to the revised version i sent earlier today that protected the actual ROMs but left a r/w gap covering the unused areas and the SMBIOS- & ACPI- tables?

-- Trolle

On Thu, Jul 24, 2008 at 1:45 PM, Keir Fraser <keir.fraser@xxxxxxxxxxxxx> wrote:
On 24/7/08 13:12, "Jean Guyader" <jean.guyader@xxxxxxxxxxxxx> wrote:

> Jean Guyader wrote:
>> I already tried to reduce the rw area, and just keep 0xe0 -> 0xef. But
>> obviously it doesn't work the device model needs to write on this frame
>> 0xf1. I still don't figure out why.
>
> The rombios write on this page because of this flags s3_resume_flag
> (rombios.c:98883). I don't know if it's a good reason to set the
> rombios as rw. However it's bad to set the first 2 pages of the rombios
> as rw just because of that.
> Any suggestions ?

In that case the changes to ioemu-remote should be reverted. The correct fix
is to move the S3 resume flag into the EBDA. I have committed this fix as
xen-unstable.hg:18120.

 -- Keir





_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel

 


Rackspace

Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.